AB 1747 - AENTR SLC 500 EtherNet/IP Adapter

In terms of software, it is compatible with specific versions of firmware, controller software and related programming software. The 1747 - AENTR requires firmware version 1.001 or higher, Logix controller version v20 or higher, RSLogix 5000 or Logix Designer software version v20 or higher, and RSLinx software version v2.59 or higher. Working together, these software packages provide a complete control and programming environment for configuring, programming, and monitoring the adapter and associated devices.

Diagnostic and Status Indicators: The 1747-AENTR adapter is equipped with a variety of diagnostic indicators that provide real-time feedback on the operating status of the device. The Module Status Indicator shows the basic status of the device, such as whether it is powered on or not, and whether it is running normally. The 4-character dot-matrix display, used in conjunction with the Module Status Indicator, not only shows the IP address of the module, but also reports on normal operation and error conditions. 

When the system starts up, the display will show the relevant startup information; if there is a fault, it will show the specific error code or prompt message to help users quickly locate the problem.Link 1 and Link 2 status indicators are used to indicate the port speed and activity of Ethernet ports 1 and 2, through the different colours and flashing status of the indicators, users can intuitively understand the status of the network connection, such as whether the connection is established, the connection speed is 10.0%, and the connection speed is 10.0%. Through the different colours and blinking status of the indicators, users can intuitively know the status of the network connection, such as whether the connection is established, whether the connection speed is 10Mbps or 100Mbps, etc.