4. Pull straight back. The module should slide out easily.
9000-RAD Card
You can install the 9000-RAD card if you have an open slot.
Before installing the card (Solid State Disk) into the 9987, jumpers and switches must be set for your par ticular configuration.
FloNet Interface Board
You can also install a IPN200 FloNet interface board in your system.
The FloNet board has two modes of operation:
Ethernet and FloNet. In Ethernet mode, the board provides a standard Ethernet network interface with user-configurable hardware in terrupts, I/O ports, and bootable ROM BIOS address location.
In FloNet mode, the FloNet board acts as the interface between a local host running FloPro software and an Ethernet LAN connected to at least one remote host platform running TCP/IP-compatible software.
The on-board firmware constantly polls the Ethernet network interface waiting for packets where are intended to communicate with FloPro.
The board will also process valid TCP/IP protocol packets.
When configured for FloPro mode, the FloNet board takes up to six eight-bit I/O ports, and 32 Kbytes of memory.
When configured as an Ethernet card, the FloNet board takes an additional 16 I/O addresses.
It may also take up an additional 32
email:1583694102@qq.com
wang@kongjiangauto.com