XYCOM Automatic 9987 Operating Interface PN.9987-3338-2100 Computer Board

The 9987 PC/AT™ Flat-panel Industrial Computer (also known as the Portrait PC) com bines a PC/AT computer with a flat-panel display to offer a powerful, compact package for the factory floor and other harsh environments. 

The 9987 features an open architec ture to meet a wide variety of applications where both a powerful PC and a durable in dustrial enclosure are required. 

The system integrates a computer card cage, mass stor age, display, keypads, and power supply in a truly industrial form factor.

The 9987 system includes a four-slot, full-length, passive ISA backplane, a VGA flat panel display, hard and floppy disk drive facilities, and data entry/function keypads. 

The front panel is sealed to NEMA 4/4X/12 standards, and the flat-panel display is protected by an impact-resistant shield. 

The open-architecture design accepts IBM PC/AT compatible cards and keyboards.

The system’s modular design allows easy access to boards, switches, power supply, and disk drives. 

You can easily remove the drawer by detaching six ACCESS fasteners.

Standard Features

Optional Features

Unpacking the System

When you remove the 9987 from its box, verify that you have the parts listed below. 

Save the box and inner wrapping in case you need to reship the unit.

Quick Start-up

Quadtel BIOS

If the CPU board has a Quadtel BIOS,  press CTRL+ALT+S simultaneously after the POST RAM test has completed to access the Setup Menu. 

Make changes by following directions on the screen. 

Press F10 to save the Setup, and ESC to exit. Refer to your CPU manual for more information on the Setup Menu.

4. Pull straight back. The module should slide out easily. 

9000-RAD Card

You can install the 9000-RAD card if you have an open slot. 

Before installing the card (Solid State Disk) into the 9987, jumpers and switches must be set for your par ticular configuration. 

FloNet Interface Board

You can also install a IPN200 FloNet interface board in your system. 

The FloNet board has two modes of operation: 

Ethernet and FloNet. In Ethernet mode, the board provides a standard Ethernet network interface with user-configurable hardware in terrupts, I/O ports, and bootable ROM BIOS address location.

In FloNet mode, the FloNet board acts as the interface between a local host running FloPro software and an Ethernet LAN connected to at least one remote host platform running TCP/IP-compatible software. 

The on-board firmware constantly polls the Ethernet network interface waiting for packets where are intended to communicate with FloPro. 

The board will also process valid TCP/IP protocol packets.

When configured for FloPro mode, the FloNet board takes up to six eight-bit I/O ports, and 32 Kbytes of memory. 

When configured as an Ethernet card, the FloNet board takes an additional 16 I/O addresses. 

It may also take up an additional 32