AB Stratix 8000 and 8300 Ethernet Managed Switches

There are also standards for vibration and shock, such as 2g @ 10-500Hz for vibration, 20g for operating shock, and 30g for non-operating shock, 

providing strong resistance to environmental interference.

Performance Features

Port auto-negotiation and self-adaptation: The ports are equipped with the functions of auto-negotiation of link speed (10 Mbps or 100 Mbps) 

and duplex setting (full-duplex or half-duplex), which can automatically match the optimal network connection parameters 

with the connected devices without manual configuration, thus improving the convenience and compatibility of device connection. 

Some models of dual-purpose ports, in the SFP module port and RJ45 port at the same time there is a connection, the SFP module port has priority, 

this design makes the network connection more flexible, according to the actual needs of the choice of different connection methods.

Multiple Configuration and Management Methods: Provides multiple configuration and management methods, including Device Manager web interface, 

RSLogix 5000 software, Cisco Network Assistant, Command Line Interface (CLI) and SNMP management application. 

Users can choose the appropriate way according to their own needs and technical level, which is convenient for initial setup, 

daily management and troubleshooting of the switch. The Express Setup function allows users to quickly set up the initial IP address of the switch, 

enabling the switch to be connected to the network for subsequent management and simplifying the configuration process during initial use.

Fault Detection and Indication: The status indicators on the front panel can visually reflect the working status of the switch, 

including power status (PWR A, PWR B indicators), EtherNet/IP module status (EIP Mod indicator), network status (EIP Net indicator), 

setup status (Setup indicator), and port status (Port indicator, etc.). 

By observing the colours and flashing status of the indicators, users can quickly determine whether the switch is working properly and find 

and locate faults in time, such as POST failure, port connection problems, etc. 

The switch will perform POST at startup. The switch will perform POST (power-on self-test) at startup, if POST fails, the system status indicator will turn red, 

which indicates that there is a fault in the device and it needs to be checked and repaired accordingly.