Motorola MVME6100 Single Board Computer Installing the Blade

Installing the Blade

Procedure 

Use the following steps to install the MVME6100 into your computer chassis. 

1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an electrical ground (refer to Unpacking Guidelines). The ESD strap must be secured to your wrist and to ground throughout the procedure. 

2. Remove any filler panel that might fill that slot. 

3. Install the top and bottom edge of the MVME6100 into the guides of the chassis. 

4. Ensure that the levers of the two injector/ejectors are in the outward position. 

5. Slide the MVME6100 into the chassis until resistance is felt. 

6. Simultaneously move the injector/ejector levers in an inward direction. 

7. Verify that the MVME6100 is properly seated and secure it to the chassis using the two screws located adjacent to the injector/ejector levers. 8. Connect the appropriate cables to the MVME6100. To remove the board from the chassis, press the red locking tabs (IEEE handles only) and reverse the procedure.

CAUTION:

Only use injector handles for board insertion to avoid damage/deformation to the front panel and/or PCB. Deformation of the front panel can cause an electrical short or other board malfunction.

Other Products in operation:

GE DS200PLIBG2A

NI BNC-2096

ABB RX835

GE IC200PBI001

HIMA BV7032-0,5

GE IC684TROLI603

HIMA EABT3 B9302 997009302

B&R 0TB103.91

HIMA F2DO 1601