System high temperature shutdown environment temperature is too high; GPU or CPU power consumption exceeds the limit; Dust accumulation on heat dissipation fins limits CPU PL1/PL2; Reduce GPU power consumption; Clean the heat sink; Add external fan
M. 2 SSDs cannot recognize protocols and do not support them (NVMe vs SATA); Confirmation of poor contact using NVMe protocol SSD; Re plug and unplug; Check if M.2 port is enabled in BIOS
GPU driver installation failed. Nouveau is not disabled; GCC version mismatch: Ensure blacklist nouveau before restarting; Install the corresponding kernel header file
2.5G network port can only negotiate 1G network cable with poor quality; The other end device does not support replacing Cat6a cables with 2.5G cables; Force setting to 2.5G (ethtool-s eth0 speed 2500)
TSN Gate Control Invalid Kernel Version Low; PTP synchronization upgrade kernel to 5.15+not enabled; Configure ptp4l and phc2sys to ensure synchronization of the master clock
COM port RS-485 sending garbled code direction control not enabled; Check if the baud rate deviation driver supports automatic RTS; If manual control is required, control the RTS pin in the application
The system cannot boot BIOS from NVMe in non UEFI boot mode; Set Boot Mode to UEFI for MBR partition table; Reinstall the system using GPT partition
Maintenance and long-term reliability
Regular dust cleaning: Fanless models rely on passive heat dissipation, and dust accumulation can seriously weaken their heat dissipation capabilities. It is recommended to use compressed air to blow back from the air inlet every 3 months to avoid dust accumulation.
Firmware update: Follow the ADLINK official website to update BIOS and ME firmware to fix CPU microcode vulnerabilities and optimize TSN performance.
Hard disk health monitoring: Enable S.M.A.R.T. monitoring and regularly backup critical data (can be mirrored regularly through M.2 NVMe and SATA drives).
Power protection: It is recommended to install surge suppressors and EMI filters at the front end to prevent damage to the motherboard caused by fluctuations in the industrial power grid.
