Bonfiglioli W110 UFC1 P100 B14 B6 Right Angle Gearbox

Product Overview

The Bonfiglioli W110 UFC1 P100 B14 B6 is a right angle gearbox with ratio 46, intended for speed reduction and torque transmission. The model reference identifies the size, motor interface, and mounting arrangement. The right angle design supports compact machine layouts where the motor and driven shaft are not in line.

The unit can be used in conveyors, packaging equipment, material handling, and general industrial machinery. Correct selection depends on output torque, input speed, duty cycle, mounting position, and environment. The gearbox should be installed by qualified personnel and according to technical documentation.

Construction and Mechanical Design

The worm gearbox contains a housing, worm shaft, worm wheel, bearings, and sealing elements. The worm and wheel arrangement provides speed reduction and torque increase in a compact layout. The housing supports the bearing arrangement and protects internal parts from contamination. Seals retain lubricant and reduce the entry of dust and moisture.

Installation requires a clean and rigid mounting surface. The gearbox should seat without distortion. Fasteners must be tightened to the specified torque and checked after initial operation. Shaft connections should be aligned carefully.

Ratio and Motor Interface

The ratio 46 defines the relationship between input speed and output speed. The designer should confirm that the output speed and torque match the driven machine. Starting torque, peak torque, and shock loads should be considered.

The P100 B14 B6 references define motor interface and mounting details. The motor flange, shaft, and pilot must match the gearbox input. Incorrect adaptation can cause vibration, misalignment, or damage. The motor should be fitted without force.

Installation and Commissioning

Before installation, the gearbox should be inspected for damage and the identification details checked. The shaft and mounting surfaces should be clean. Alignment with the motor and driven machine should be verified. Guards should protect rotating parts.

Commissioning should begin with a low load run where possible. Rotation direction, noise, vibration, leakage, and temperature should be checked. Fasteners should be rechecked after initial operation. The lubricant level should be confirmed according to the mounting position.

Lubrication and Thermal Conditions

Lubrication reduces friction and wear and helps remove heat from the gear mesh and bearings. The specified lubricant type and quantity must be used. The mounting position determines the correct oil level and plug arrangement. Fill, level, and drain points should remain accessible.

Operating temperature should remain within the intended range. The housing should have adequate air flow. Excessive temperature can indicate overload, incorrect lubricant, or inadequate cooling.

Operation and Monitoring

During operation, the gearbox should run smoothly within the designed speed and torque range. Operators should monitor noise, vibration, temperature, and leakage. A change in running sound can indicate wear or lubrication problems.

Load changes can affect gearbox life. Increased throughput, higher torque, frequent reversing, or shock loading should be reviewed against the original selection.

Protection and Maintenance

Reliability depends on correct mounting, suitable lubrication, and protection from contamination. Seals should be inspected for damage. The gearbox should not be exposed to water, dust, or corrosive substances beyond its intended protection level.

Maintenance should include periodic inspection of lubricant, seals, fasteners, and housing condition. Before service, the machine must be isolated and secured against rotation.

Integration and Selection Summary

The W110 UFC1 P100 B14 B6 gearbox can be integrated into industrial machines that require compact right angle speed reduction and torque transmission.

Selection should confirm the model W110 UFC1 P100 B14 B6, ratio 46, motor interface, shaft arrangement, torque capacity, mounting position, and lubrication requirements. The designer should verify compatibility with the motor and driven machine.