[Bently] BENTLY 1900/65A General Purpose Equipment Monitor

2025-09-19

The 1900/65A General Purpose Equipment Monitor is designed to continuously monitor and protect equipment that is used in a variety of applications and industries. The monitor’s low cost makes it an ideal solution for general purpose machines and processes that can benefit from continuous monitoring and protection.

[Bently] Bentley Baker Hughes 2300 Series Vibration Monitors

2025-09-15

The 2300 Vibration Monitors provide cost-effective continuous vibration monitoring and protection capabilities for less critical and spared machinery. They are specifically designed to continuously monitor and protect essential medium to low criticality machinery in a wide range of industries including: oil & gas, power generation, water treatment, pulp and paper, manufacturing, mining, cement,and other industries.

[Bently] Bently Nevada 3300 XL 8mm Proximity Sensor System

2025-09-12

Based on the principle of eddy current induction, a voltage signal proportional to the distance between the probe tip and the conductive surface is output, which can simultaneously measure static position (such as radial/axial position of the shaft) and dynamic vibration (such as vibration of rotating equipment). It also supports Keyphasor signal reference and speed measurement, mainly used for state monitoring of fluid film bearing equipment.

[Bently] Bently Nevada 3300 XL High Temperature Proximity Detection System (HTPS)

2025-09-06

Addressing the pain point of traditional proximity probes being easily damaged in high-temperature environments, it can operate stably in continuous high temperatures up to+350 ° C (+662 ° F) and is used to measure key parameters such as vibration, thrust position, and differential expansion. It is compatible with Bently Nevada's entire range of monitoring and diagnostic equipment.
Combining the dual value of "online monitoring and protection" and "research and development/troubleshooting": it is used for real-time protection of key equipment in industrial sites, and also supports turbine mode shape analysis, helping new machine research and development and old machine fault diagnosis (such as shaft cracks, bearing failures, dynamic and static friction, etc.).