Bonfiglioli BN80B4 Electric Motor 8F31020004
The Bonfiglioli BN80B4 Electric Motor is an industrial asynchronous motor identified by the BN80B4 model reference and the material reference 8F31020004. The BN80 frame is a common size in the Bonfiglioli motor range, and the B4 designation indicates a four pole configuration, which corresponds to a synchronous speed of about 1500 rpm at 50 Hz and about 1800 rpm at 60 Hz.
The material reference 8F31020004 is useful when ordering or comparing units, because the same frame size can be supplied with different voltages, mounting arrangements, and protection classes. The nameplate should be treated as the primary source for the electrical data.
Frame and Pole Configuration
The frame 80 designation defines the mechanical interface, the shaft dimensions, and the approximate power range. The four pole configuration provides a moderate speed with reasonable torque density. The actual rated speed is slightly below the synchronous speed because of slip, and the nameplate value should be used for calculations.
The motor should not be exposed to loads beyond its specified capacity. Misalignment, excessive vibration, and incorrect voltage can affect bearings, windings, and insulation. The machine design should provide adequate support and protection.
Nameplate Review and Compatibility
The nameplate supplies the rated voltage, frequency, current, power factor, speed, and connection method. These values should be compared with the supply and with the driven machine. If the motor is controlled by a drive, the motor data should be entered into the drive and the protection settings reviewed.
Compatibility includes the mounting flange, shaft dimensions, and coupling arrangement. If the motor is part of a geared drive, the gearbox interface should be checked.
Mechanical Installation
The motor should be mounted on a rigid structure that can support its weight and torque. The mounting surface should be clean and flat. Fasteners should be tightened to the specified values. The motor should not be distorted by uneven mounting surfaces or excessive bolt force.
Shaft alignment should be checked carefully. Couplings should be aligned within the limits allowed by the coupling and motor design. Belt, chain, or gear connections should follow the machine design. Impact on the shaft during installation should be avoided.
Electrical Connection
Electrical connection should be performed by qualified personnel following the site electrical code. Supply voltage, frequency, and winding connection must match the motor nameplate. Terminal connections should be correct and secure. Protective earth should be connected according to the installation requirements.
Cable sizes should be selected for current and voltage drop. Cable entries and glands should maintain the enclosure protection. The motor should be protected against short circuit and overload.
First Run and Verification
Before the first run, the motor should be inspected for correct mounting, secure connections, and free rotation. The motor should be uncoupled from the load where practical to confirm the direction of rotation. After coupling, the machine should be run at low load and observed for current, vibration, noise, and temperature.
Commissioning records should include the motor reference, material reference, nameplate data, connection details, and test results.
Maintenance and Troubleshooting
Routine maintenance should include checking mounting bolts, couplings, cables, and ventilation. The motor should be kept clean and free from contamination that could affect cooling. Bearing noise and vibration should be monitored. Loose connections should be corrected.
If the motor overheats, the user should review load, duty cycle, ambient temperature, and ventilation. If the motor runs noisily, alignment, bearings, and coupling should be checked. If the motor does not start, supply, control, and protection should be reviewed.
Application Value
The BN80B4 motor supports rotary drive power in compatible machinery. It can be applied in industrial applications where an 80 frame four pole motor fits the design. The actual performance depends on correct selection, mounting, electrical connection, and maintenance.
Summary
The Bonfiglioli BN80B4 Electric Motor is intended for compatible industrial drive applications. Correct nameplate verification, mounting, alignment, electrical connection, commissioning, and maintenance are essential for reliable service.
