DS3800HLNE | General Electric Network Controller Board

DS3800HLNE | General Electric Network Controller Board

Product Description P/N: DS3800HLNE DESCRIPTION / SPECIFICATIONS Description The DS3800HLNE General Electric Network Controller Board is designed for efficient network management in industrial control systems. It facilitates reliable communication and data exchange between system components. Built for robustness and high performance, it ensures seamless integration and operation in demanding environments. Technical Specifications Condition New / Never Used Surplus Brand General Electric Category PLCs/Machine Control Part Number DS3800HLNE Subcategory PC Board PLC/Add-On Board Type Network Controller Board Series Mark IV Series Board Type Control / Network Interface Communication Protocol GE Mark IV proprietary protocol Voltage Rating 5V DC (standard logic level) Operating Temperature 0掳C to +60掳C Storage Temperature -20掳C to +85掳C Humidity Range 5% to 95% non-condensing Information About DS3800HLNE The GE Network Controller Board DS3800HLNE, used in various applications, is equipped with a modular connector on one end and retention levers on the other.

 It features a microprocessor, multiple transistor-transistor logic (TTL) devices, three red LEDs, one amber LED, several EEPROM sockets, 16 jumpers, and a 34-pin connector. The microprocessor on the DS3800HLNE manages the board鈥檚 networking functions. Installed in a socket embedded on the board, it generates heat during operation, necessitating adequate cooling. To ensure proper cooling, install the board in a rack location with at least 3 inches of open space around it, allowing air to flow freely over the microprocessor. Ensure that ribbon cables inside the drive do not obstruct airflow. If the drive shuts down, use diagnostic tools to check the error log, which may indicate an overheat condition that triggered the automatic shutdown. Before restarting the drive, verify that air vents at the top and bottom are clear to prevent overheating. 

 Manufacturer information General Electric (GE) is a multinational conglomerate founded in 1892, based in the United States. It operates in various industries, including aviation, healthcare, renewable energy, and power. GE is known for its innovations in technology, manufacturing, and infrastructure solutions. IQElectro is not an authorized distributor. QElectro LLC (IQElectro) is NOT an Authorized Distributor or in any way affiliated with Rockwell Automation, Siemens, or any other Manufacturers. IQElectro is NOT an Authorized Dealer of this product. The product may be of older version, date codes, or design than that available from authorized dealers. As IQElectro is not an authorized dealer of this product, the Original Manufacturer's Warranty and Support DO NOT apply.IQElectro sells SURPLUS onlyand DOES NOT SELL SOFTWARE or FIRMWARE licenses For more detailed information, please refer to the full version of our disclaimer policy Disclaimer Policy.

Instructions and warnings related to the operation of the product:

The following specifications must be strictly observed:

l The technical specifications and typical applications of the product system must be strictly observed.

l PERSONNEL TRAINING: Only trained personnel may install, operate, maintain or repair the product system. These personnel must be instructed on the

Hazardous area conditions must be instructed and explained to these personnel.

l Unauthorised modifications: No modifications or structural changes may be made to the product system.

l Maintenance Responsibility: It must be ensured that the product system is only used under appropriate conditions and in a condition that is fully fit for purpose.

l Working environment: The user must fulfil the specified environmental conditions:

Safety regulations

The following safety regulations must be fully observed when (maintenance) work is carried out on the product system:

1 Disconnect completely.

2 Secure to prevent reconnection.

3 Confirm that the installation has been completed.

4 Perform grounding and short-circuiting.