The National Instruments FP-1000 is a network module for FieldPoint distributed I O systems. It provides an RS-232 port for direct connection to a host computer and an RS-485 repeater port for connecting additional FieldPoint nodes. The module uses the industry standard Optomux protocol and includes a built in power supply for the I O modules on its backplane. It is used in industrial monitoring, process control, and remote data acquisition where I O is distributed across a facility.
FieldPoint systems are built from a network module, terminal bases, and I O modules. The FP-1000 serves as the communication gateway for the node. It converts commands from the host into I O operations and returns measurement data. The RS-485 repeater port allows multiple nodes to be connected in a network, supporting larger distributed systems without a separate repeater device.
Communication Ports
The FP-1000 provides one RS-232 port and one RS-485 repeater port. The RS-232 port connects directly to a PC or controller. The RS-485 port allows connection to additional FieldPoint network modules, forming a multi node network. Engineers should verify baud rate, data format, and protocol settings for the host software.
Supported baud rates cover a range suitable for both short and long cable runs. Lower baud rates support longer distances, while higher rates improve throughput on shorter networks. The Optomux protocol is ASCII based and widely supported in industrial software.
Power and I O Backplane
The FP-1000 includes a built in high efficiency power supply that powers the I O modules connected to its backplane. Input power can range from 11 to 30 VDC. Engineers should calculate the total power draw of the installed modules and confirm that the supply can deliver the required current.
The backplane distributes power and communication to the I O modules. Module order and addressing should be documented so that channel mapping remains consistent. The operating temperature range extends from 40 to 70 degrees Celsius below zero in some configurations, supporting industrial environments.
Network Topology and Expansion
The RS-485 repeater port supports four wire mode and allows multiple nodes to be linked. Up to 24 FP-1001 network modules can be connected to a single FP-1000 in a serial network. This architecture supports distributed I O across a machine or process area while keeping the host connection simple.
Network planning should consider cable length, termination, and node addressing. Shielded twisted pair cable is recommended for RS-485 networks in electrically noisy environments.
Applications
The FP-1000 is suited to process monitoring, remote I O, machine control, and industrial automation. It provides the communication foundation for FieldPoint systems that place I O close to sensors and actuators.
Installation and Maintenance
Installation requires mounting the module on a DIN rail or panel, connecting power and communication cables, and inserting I O modules. Wiring should be labeled and secured. The enclosure should provide adequate ventilation and protection.
Maintenance includes checking connections, verifying communication with each node, and reviewing power consumption. Documentation of node addresses and module positions helps troubleshooting.
Summary
The National Instruments FP-1000 FieldPoint Network Module provides RS-232 and RS-485 connectivity for distributed I O systems using the Optomux protocol. It includes a built in power supply and supports multi node networks. The module is a practical communication foundation for FieldPoint installations in industrial monitoring and control.




