Product Overview
The National Instruments MID-7604 and MID-7602 are motion interface devices used with NI motion control cards. They provide the interface between the motion controller and the motor drives, including signal conditioning, connector interfaces, and drive connectivity. The MID-7604 supports four axes, while the MID-7602 supports two axes.
These interface devices are part of the NI motion control ecosystem. They simplify the connection between a PCI or PXI motion control card and industrial stepper or servo drives, reducing wiring complexity and improving system reliability.
Drive Interface
The MID devices provide the connectors and signal conditioning needed to connect motion control cards to stepper and servo drives. They handle command signals, encoder feedback, and limit and home switch inputs. Engineers should confirm the supported drive types and signal formats for the specific MID model against the product documentation.
Correct wiring between the motion card, MID device, and motor drive is essential for reliable motion. Engineers should verify signal levels, polarity, and connector pinouts before powering the system, and should follow the drive manufacturer instructions for command and feedback connections.
Axis Count and System Size
The MID-7604 supports four axes, while the MID-7602 supports two axes. The choice between models depends on the number of motion axes in the application. Engineers should plan the axis count with some allowance for future expansion where practical.
Multi axis systems require coordinated motion and careful cable management. Engineers should route motor power, encoder feedback, and limit switch wiring separately from sensitive measurement signals to reduce noise coupling.
Installation and Safety
Motion systems involve moving machinery and hazardous voltages. The MID devices and associated drives should be installed in an enclosure that provides protection and adequate ventilation. Engineers should follow the installation instructions and applicable safety standards.
Emergency stops, limit switches, and other safety devices should be wired to hardwired safety circuits and should not depend solely on software for protection. Engineers should verify that the motion system stops safely when a limit or fault condition occurs.
Software and System Integration
The MID devices work with NI motion control software and motion control cards. Engineers can configure axes, define move profiles, and coordinate motion with other tasks in LabVIEW, LabWindows/CVI, Measurement Studio, and other compatible development environments.
Motion applications should include error handling, status monitoring, and recovery procedures. Engineers should log axis position, velocity, and fault conditions during commissioning and production to support diagnosis and continuous improvement.
Typical Applications
Multi axis motion control systems
Automated test stands with positioning
Pick and place and assembly equipment
Laboratory motion and scanning systems
Machine control with stepper or servo drives
Industrial automation with NI motion cards
The MID-7604 and MID-7602 provide the interface between NI motion control cards and stepper or servo drives. Their drive connectivity and multi axis support make them practical accessories for integrated motion control systems.




