Product Overview
The National Instruments PCIe-6738 is an analog output card for PCI Express computers. It provides 32 analog output channels with 16 bit resolution. The card is designed for applications that require many analog command signals, such as multi axis control, waveform generation, stimulus response testing, and hardware in the loop simulation.
The PCIe-6738 is part of the NI analog output product family. It installs in a PCI Express slot and is supported by NI-DAQmx software. Its high channel count makes it suitable for test systems that must generate many independent analog signals from one computer.
Analog Output Performance
The card provides 32 analog output channels with 16 bit resolution. Selectable output ranges allow the card to match the requirements of the driven device. Hardware timed output supports deterministic waveform generation, and the update rate is sufficient for dynamic waveform and control profile generation.
Each channel provides 16 bit resolution, which supports fine adjustment of output levels. Engineers should verify settling time and output noise for the required application, especially when driving high capacitance or inductive loads. External protection may be needed for loads that can feed voltage back into the output.
Multi Channel Output
Thirty two output channels in one card allow many actuators or signal inputs to be controlled from a single PCI Express slot. This reduces the number of separate cards and cables required in a test rack. Engineers should plan channel mapping carefully so that each output is associated with a known device and function.
Hardware timed updates support repeatable sequences across multiple channels, which is useful for coordinated stimulus and control profiles. Engineers should document the update timing and any synchronization between channels.
Timing and Synchronization
NI-DAQmx provides sample clock and trigger configuration for the PCIe-6738. Start triggers, reference triggers, and pause triggers allow output generation to be aligned with external events. The card can be synchronized with other DAQ devices where the system architecture supports shared timing and triggering.
Engineers should document the clock source and trigger routing so that the output sequence can be reproduced. Careful planning reduces uncertainty when correlating output commands with measured responses.
Software and Accessories
The PCIe-6738 is supported by NI-DAQmx and can be programmed with LabVIEW, LabWindows/CVI, Measurement Studio, and other NI-DAQmx compatible environments. The driver handles channel configuration, output range selection, timing, and trigger setup. Screw terminal and mass termination accessories are available for different wiring needs.
Installation requires a PCI Express slot with adequate airflow and a host computer within the supported specifications. Cables should be routed away from power switching equipment, and shields should be terminated according to the accessory documentation.
Typical Applications
Multi channel waveform generation and stimulus
Actuator and valve command profiles
Hardware in the loop test and simulation
Multi axis motion command generation
Calibration signal generation
PCI Express based automated test systems
The PCIe-6738 provides 32 channels of 16 bit analog output in a PCI Express card. Its channel count and hardware timed output make it suitable for multi channel control and waveform generation applications.




