REXROTH VT-HNC100... 3X Series Digital Axis Controller

Project creation and parameterization: Use software wizards or the "first step" guide to create a new project, configure controller parameters based on actual hydraulic axes and sensors, and define motion programs.

Initialization and Download: Compile and download (initialize) the complete project data (including parameters and programs) to VT-HNC100... 3X controllers.

Run test: After initialization is complete, the controller enters the "RUN" state, which can accept higher-level control instructions and execute pre programmed motion sequences.

The "First Steps" document provided on the official website is a quick guide to getting started with WIN-PED ® An excellent guide to software and completing initial debugging.

Operation, maintenance, and troubleshooting

1. Normal operation

During normal operation, users usually do not need to intervene. Even if a power failure occurs during operation, the controller can immediately return to a ready state after being powered on again, without the need for additional measures.

2. Cleaning and maintenance

Regularly clean the surface of the casing with a dry and dust-free soft cloth to prevent the accumulation of dirt and moisture.

It is strictly prohibited to use solvents or corrosive cleaning agents.

At least once a year, check the firmness and integrity of all plug-in and crimping connections, and inspect the cables for any damage or compression.

Keep the environment around the device clean and comply with IP20 protection requirements.

3. Maintenance and replacement

VT-HNC100... 3X can only be replaced as a whole unit and users are not allowed to disassemble and repair it themselves.

All repair work must be carried out by authorized service departments of Bosch Rexroth.

The repaired equipment needs to be sent in its original packaging to the designated service address (such as the main factory in Lor, Germany). The repaired device will revert to factory default settings, and users will need to re import all specific parameters and programs.

4. Troubleshooting steps

Systematic troubleshooting: Avoid blindly disassembling or adjusting parameters. Firstly, understand the working principle of the product in the entire system.

History and Change Investigation: Confirm whether the system or product has undergone any changes, repairs, or unexpected use before the malfunction occurred.

Utilizing diagnostic tools: fully utilizing WIN-PED ® The built-in diagnostic function of the software monitors I/O status, parameter records, and error messages online. Diagnosis and fault information can also be read through fieldbus.

5. Scrapping and environmental treatment

Products and packaging materials should be disposed of in accordance with the current regulations of the country where they are located. The product is mainly composed of electronic components and assemblies, and does not contain hazardous materials that may be released during use. Due to the high metal content, most of the products are recyclable. If it contains batteries or accumulators, they should be removed and sent to a dedicated battery recycling channel before recycling. Bosch Rexroth also provides product recycling services.