ABB SC510 submodule carrier (without CPU)
Product basic information
Category details
Core Identification - Product ID: 3BSE003832R1
-ABB model name: SC510
-Product description (including brief/long description): SC510 without CPU submodule carrier
Product Type Communication-Module
Order related - HS code: 853890 (applicable to specialized or major parts of equipment under items 85.35, 85.36, or 85.37, other categories)
-Customs tariff number: 85389091
Physical specifications
Dimensions: Product net depth/length 288mm, net height 22.5mm, net width 486mm.
Weight: The net weight of the product is 0.67kg.
Environment and Compliance
Compliance category and specific requirements
RoHS status, compliant with EU Directive 2011/65/EU
WEEE category, category 5 (small equipment with no external dimensions exceeding 50cm)
Number of batteries, 0 (without built-in batteries)
SCIP information, identification number: 64ca723a-0669-4eec-a128-1d20dd256d13, associated region: Sweden (SE)
Suite application scenarios (as a component of the "suite")
SC510 can be used as a component of the following kit, with specific kit information as follows:
Kit identifier, kit description, type
3BSE011302R1, ACMHWV16 hardware PM510V16, SC510 and MB510, Kit
3BSE016433R1、 Not labeled with specific description, Kit
3BSE016434R1、 Not labeled with specific description, Kit

Product classification attribution
SC510 belongs to the communication module, and its specific product classification system is as follows, covering different control systems and versions:
Control system products → Control and communication → AC 400 → AC 400- Communication module → SC510 submodule carrier → SC510 submodule carrier
Control System → Advant OCS with Master Software → Controller → Advant Controller 450 → Advant Controller 450 Version 2.3 → Communication Module
Control system → Advant OCS with MOD 300 software → Controller → AC460 → Communication module
Control System → Advant OCS with Master Software → Controller → Advant Controller 450RMC → Advant Controller 450RMC 2. x → Communication Module
Safety specifications are generally applicable to control system handling. Instructions and warnings related to a specific subject or operation of the product.
The following norms must be strictly observed:
must strictly comply with the technical specifications and typical applications of the product system
Personnel training: Only trained personnel shall install, operate, maintain or repair the product system. must
Provide guidance and explanation of the situation in danger areas to these personnel.
Unauthorized changes: Changes or structural changes to the product system may not be made.
Maintenance responsibility: Must ensure that the product system is used only under appropriate conditions and in full fitness for use.
Working environment: The user must meet the specified environmental conditions:
Safety regulation
The following safety provisions of EN 50110-1 shall be fully complied with when handling product systems (maintenance) :
1 Disconnect completely.
2 Secure to prevent reconnection.
3 Verify that the installation is complete.
4 Ground and short-circuit the device.
Warning: Only qualified maintenance personnel can remove and insert the module. In order to ensure the personal safety of the operator, before each pulling out or inserting, you must
Disconnect the power supply and ensure that there is no voltage on all terminals at the back, and the product is effectively grounded with the ground screw at the back.
