Advantest R3267 Spectrum Analyzer
Advantest R3267 Spectrum Analyzer
INTRODUCTION
The 3267/3273 features a frequency span accuracy within ±1% and a dynamic range of -154 dBc/Hz (typ) in the 2 GHz band to allow accurate, repeatable measurements for high-quality digital signals. Further, its 10 Hz to 10 MHz resolution band with filter and ability to perform a 70 dB (typ, at 5 MHz offset) ACP measurement on WCDMA makes it ideal for testing of wide band signals. Finally, with a frequency range from 100 Hz to 8 or 26.5 GHz, the R3267/3273 allow comprehensive measurements of even high frequency systems.
High Frequency and Wide Bandwidth Measurements
Frequency range: R3267 100 Hz to 8 GHz R3273 100 Hz to 26.5 GHz
Resolution bandwidth: 10 Hz to 10 MHz
Span accuracy: ±1% or better (for all spans)
High Dynamic Range Measurements
Dynamic range: -154 dBc/Hz (2 GHz band, typ.) 70 dB or better (5 MHz offset, typ.) for W-CDMA ACP measurement
Outstanding Signal purity: -113 dBc/Hz (10 kHz offset)
Input attenuator: 75 dB in 5 dB steps (R3267)
1 dB gain compression: 0 dBm
3rd order intermodulation distortion: -80 dBc or less
The key features of the analyzer are listed below:
• Wide frequency ranges: R3264 9 kHz to 3.5 GHz R3267 100 Hz to 8 GHz R3273 100 Hz to 26.5 GHz
• Excellent signal purity: -110 dBc/Hz 10 kHz offset
• Low noise level: R3264 -146 dBm/Hz or less (at 2 GHz) R3267/73 -148 dBm/Hz or less (at 2 GHz)
• High-speed zero span sweep: 1 µsec
• Precision level measurements
• High-speed measurements with 20 traces/sec
• Various types of interface that permit an easy systematization: GPIB, parallel and RS232 interfaces
• A 3.5-inch floppy disk drive equipped as standard (Compatible with MS-DOS)
Environmental Conditions
The R3267 Series should be only be used in an area which satisfies the following conditions:
• Ambient temperature: 0°C to +50°C (operating temperature)
• Relative humidity: 85% or less (without condensation)
• An area free from corrosive gas
• An area away from direct sunlight
• A dust-free area
• An area free from vibrations
• A low noise area Although the R3267 Series has been designed to withstand a certain amount of noise riding on the AC power line, it should be used in an area of low noise. Use a noise cut filter when ambient noise is unavoidable.
• An area allowing unobstructed air flow There is an exhaust cooling fan on the rear panel and exhaust vents on both sides and the bottom (toward the front) of the R3267 Series. Never block the fan and these vents. Keep the rear panel 10 centimeters away from the wall. In addition, do not use the R3267 Series upright turned the rear panel side down. The resulting internal temperature rise will affect measurement accuracy.
Our Main Brands
· - ABB Advant-800xA,Advant OCS,Bailey Infi 90 and Net 90,H&B Freelance 2000,DSQC Robots,IGCT / IGBT
· - GE General Electric Field Control, Genius I/O, QuickPanel, RX3i PacSystem, Series 90, Series 90, Series VersaMax
· - Allen Bradley Allen-Bradley SLC500, MicroLogix, CompactLogix, ControlLogix, PLC-5, Panel View,
· - Bently Nevada 3300 System, 3500 System
· - Honeywell 7800 Series, FSC, IPC, Mxopen, TDC 2000, TDC 3000, Experion PKS(C200,C300)
· - Yokogawa Centum CS - Centum VP, Centum XL - micro XL, FA-M3, ProSafe-PLC
· - Ovation, Foxboro, EPRO, Emerson DeltaV, Fuji, Siemens, HIMA, Prosoft, Invensys Triconex, ICS TRIPLEX, Woodward, Bachmann, Schneider
email:1583694102@qq.com
wang@kongjiangauto.com