GE IS200SRLYH2A - SIMPLEX TB RELAY

GE IS200SRLYH2A - SIMPLEX TB RELAY

Part Number IS200SRLYH2A Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI Function Module Availability In StockIS200SRLYH2A is a Simplex Relay Output Terminal Board manufactured and designed by General Electric as part of the Mark VIe Series used in GE distributed turbine control systems. The Simplex Relay Output (SRLY) terminal board is a simplex S-type terminal board that accepts a PDOA/YDOA I/O pack and offers 48 customer terminals for 12 form C relay output circuits. The physical dimensions, customer terminal placements, and I/O pack mounting of SRLY are identical to those of other S-type terminal boards. A connected PDOA or YDOA I/O pack will be the highest component, allowing for double stacking of terminal boards. Each relay on SRLY feeds PDOA and YDOA its position using a single, isolated contact pair. 

 INSTALLATION: A sheet metal carrier with SRLY and a plastic insulator installed on it is fastened to a cabinet with screws. Option boards can be plugged into SRLYH2A or SRLYS2A and are held in place by the connectors' force. The purpose of each terminal point in relation to the existence of an option board is described in the following table. OPERATION: There are two different groups of SRLY. Option board connectors JW1 and JW2 are absent from the SRLY1A and are replaced by fixed box terminals. With connectors JW1 and JW2, the option board connection on the SRLY2A is supported by pluggable type terminals. Each of the 12 relays in SRLYH2's electrical circuit is configured as follows: SRLY Terminal Board Grouping The SOL terminal connected to each relay has no connection in the absence of an option board. On all customer screw and JW1 circuits, SRLY is intended to support a current rating of 5 A and a voltage clearance greater than required for 250 V ac. 

The limiting factor for each application is the relay rating. CONFIGURATION: The SRLY terminal board doesn't have any jumpers. Six jumpers on option board WROBH1 are used to turn on or off power to a relay. With each of the six jumpers in position, boards are created. When a relay is to be utilized with dry contacts and no power distribution is intended, the jumper is removed from the board. The WROFH1 board is not connected to any jumpers. The terminal point selected as the relay common determines whether a series fuse is included or excluded for each relay. To enable direct use of the fuse voltage sensing circuit as a voltage detector, the WROF fuse connected with each relay may also be eliminated.Module manufactured by General Electric as part of the Mark VI/VIe Series used in gas turbine sppedtronic control systems

Benefits

 Single slot CPU 

 Provides 1 Mbyte of battery-backed memory in the same slot (up to 512 Kbytes available for use by ladder diagram application program)  Supports floating point calculations 

 Up to 12K discrete inputs and outputs (any mix - simplex mode only); 2048 voted discrete inputs, 2048 voted discrete outputs Up to 8K analog inputs (simplex mode only) and 8K analog outputs (simplex mode only); 1024 voted analog inputs 

 0.4 microseconds per boolean function 

 64 MHz, 80486DX2 microprocessor 

 Supports IC660/IC661 I/O (and IC697 I/O in simplex mode only) 

 Programmed by MS-DOS

, or Windows

 software products running on Windows

 95 or Windows NT

 over Ethernet TCP/IP or through the SNP port. 

 Configurable data and program memory 

 Battery-backed calendar clock 

 Three position operation mode switch 

 Password controlled access 

 Remote programmer keyswitch memory protection 

 Four status LEDs 

 Software configuration (No DIP switches or jumpers) 

 Reference information inside front door 

 In-system upgradable firmware