MOOG M-DRIVE INSTALLATION FOLLOWER OPERATION

MOOG M-DRIVE INSTALLATION FOLLOWER OPERATION

FOLLOWER OPERATION Complete the ìScalingî and ìTuningî procedures for Master mode (Page 2) before proceeding with Follower opera tion. To enable Follower operation, follow the procedure below:

1.Wiring additions:

2. Enter the pulses-per-revolution of the lead (External Reference) sensor into CP-30 (PPR Ext Ref).

3. Enter the maximum system operating RPM of the lead motor (or sensor shaft if not directly connected to the motor) into CP-36 (RPM Ref Secondary Max).

4. The M-Drive is now scaled for ratio follower operation. Setpoint and display values are in ratio of follower/lead. If engineering unit setpoints and/or displays other than ratio are desired, refer to Chapter 5 of the ìM-Drive User Manualî. 

5. Enter the desired operating ratio into CP-3 (Follower Setpoint).

TROUBLE-SHOOTING

Master Mode: Motor Will Not Run 

Step 1: Check MV-53 (Control State). a) Should be ì32î (Run). b) If not ì32î, check the Run, R-Stop and F-Stop wiring. 

Step 2: Check MV-45 (Scaled Reference). a) Should not be zero. b) Press ìSETSPEEDî and enter a midrange value setpoint. c) Enter a value greater than max motor speed (CP-34) into CP11 (Maximum Limit). d) Enter a ì1î into CP-61 (Scaling Mode Pri) and CP-63 (Display Mode Pri). 

Step 3: Check MV-46 (Ramped Reference). a) Should not be zero. b) If MV-46 is zero, check MV-54 for a value of 247 or 255. c) If MV-54 is not 247 or 255, check wiring according to Chapter 3 of the ìM-Drive User Manualî.

Step 4: Check MV-47 (Output). a) Should not be ì0î or ì100î. b) If"0", then return to step 1 of ìScalingî. c) If ì100î, check wiring to motor. 

Step 5: If armature contactor is used, make sure it is energized.

Other Products in operation:

FOXBORO FBM39

ABB PPD113

TRICONEX   9662-1

MOTOROLA  MVME177-011

MOTOROLA  MVME162-532

Schneider  AS-BDAU-204

NI SCXI-1166

TRICONEX   3604E

NI PCI-1427

ABB KUC711AE101 3BHB004661R0101

GE 176373C8443AKG04 MK5 CIRCUIT BOARD

ABB PM825 3BSE010796R1

GE IC086SLM082

MOTOROLA  MVME177-011

MOTOROLA  MVME162-532

Schneider  AS-BDAU-204

NI SCXI-1166

TRICONEX   9662-1

MOTOROLA  MVME177-011

MOTOROLA  MVME162-532

Schneider  AS-BDAU-204

NI SCXI-1166

GE IC660EBD020

MOTOROLA  MVME2700-1361

GE IC200ACC302