The DM30K1101-D is a servo drive within the Bosch Rexroth DM series, part of the SERVODYN-D drive range. It is a modular drive amplifier designed for rack mounting in a common DC bus architecture, where multiple drives share a regulated DC link. The drive’s regulated DC link is approximately 670 VDC, and its three-phase output stage delivers a rated output current of approximately 8.2 A. These characteristics place the DM30K1101-D in the domain of medium-power servo axes that operate from a shared DC supply rather than from individual rectifiers.
The DM30K1101-D operates from a DC link that is nominally regulated at 670 VDC. In configurations where the DC link is not regulated, the voltage is approximately 715 VDC. The difference between the regulated and non-regulated values reflects the operating conditions of the upstream power supply and the loading on the common DC bus. The drive’s output stage inverts the DC link voltage to produce a three-phase variable-frequency, variable-voltage output for the servo motor. The rated output current of 8.2 A defines the continuous current capability of the drive, while the peak current capability is higher to accommodate acceleration transients.
The drive is designed with a modular width of 50 mm and a height of 430 mm, allowing multiple DM drives to be mounted side by side in a rack. The DC link connection is made through busbars, which distribute the DC voltage across the drives in the rack without individual power cabling to each module. This busbar architecture reduces wiring complexity and supports the common DC bus concept, in which energy regenerated by one axis can be absorbed by other axes or by a regenerative supply unit.
The DM30K1101-D is equipped with a SERCOS interface for communication with a higher-level motion controller. SERCOS provides deterministic cyclic data exchange, carrying position commands to the drive and returning actual position, velocity, and status information to the controller. The drive also includes a standard encoder interface for motor feedback, supporting the feedback types used by the compatible servo motors in the system. The combination of SERCOS communication and local encoder evaluation allows the drive to close its velocity and current loops using the motor feedback, while receiving position setpoints over the bus.
The drive’s control architecture is oriented toward operation within a multi-axis system, where a central motion controller coordinates the axes over SERCOS. The DM30K1101-D therefore functions as a drive amplifier that executes the current and velocity control tasks locally, while relying on the higher-level controller for trajectory generation and position loop closure. This division of control responsibilities is characteristic of the SERVODYN-D and related Rexroth drive families.
The DM series drives incorporate monitoring functions for overcurrent, overvoltage, and overtemperature conditions, protecting the power stage and the connected motor. The drive’s thermal design accounts for the heat generated by the output stage and the control electronics, with the rack mounting and the 50 mm width providing a defined airflow path within the cabinet. The 670 VDC DC link voltage requires that the drive be installed in accordance with the clearance and insulation requirements for high-voltage DC systems, and the busbar connections must be torqued and maintained according to the specified procedures.
The drive is intended for use with servo motors that are compatible with its current rating and feedback interface. The output current of 8.2 A defines the motor winding characteristics that can be driven continuously, while the DC link voltage determines the maximum back-EMF and therefore the speed range of the motor at full torque. The SERCOS interface and the standard encoder interface together provide the communication and feedback paths required for closed-loop servo operation.
In a complete system, the DM30K1101-D occupies a drive slot in a rack alongside other DM drives and a common power supply or regenerative unit. The SERCOS network connects the drives to the motion controller, and the DC busbars distribute power across the rack. The drive’s local control loops regulate motor current and velocity, while the controller manages the coordinated motion of the axes. The DM30K1101-D is therefore a component in a modular, multi-axis drive architecture, characterized by its 670 VDC regulated DC link operation, 8.2 A output rating, SERCOS communication, and rack-mounted 50 mm format.



