Profibus Module FI 830F

Features 

… PROFIBUS-DP Module (DIN 19245) 

… Transmission rate up 12 MBd 

… supports up to 126 slaves 

… Physical interface: RS485 

… Electrical isolation 

… Shared memory (256 KB) onboard, to minimize the use of basic unit memory. 

… Module can be removed or inserted during operation 

… Redundant operation, with redundant AC 800F

Description 

The FI 830F module interfaces to the Profibus fieldbus. It provides functionality according to the PROFIBUS-DP V1 standard (DIN 19245 amendment 1) and supports baud rates up 12 MBd. 

The module is the master on the Profibus line and allows connecting up to 126 Profibus slaves. Configuration and parameterization is carried out completely with Control Builder F — no additional external configuration tools are required. 

Line redundancy can be achieved using an external device (RLM 01) which drives two Profibus lines in parallel. In conjunction with a second AC 800F the module can also operate in a redundant-master mode without limiting any other feature.

Front Panel Connections 

Profibus 9-pin female connector (DIN 41652)

LED Displays 

State 

 Off No supply power, module is isolated 

 Green Module is active and working properly 

 Orange Module has been identified by AC 800F, but has not yet been activated 

 Red Module powered up, but not yet identified, or an error has occurred Busy 

 Off Module is in passive state on the Profibus. 

 Green Module has token and, thus, is acting as the master

Technical Data

Power consumption In the active state, depends on the communication cycle time: 

2.8 W 

Max. output current 20 mA for bus termination/repeater supply 

Output voltage 5 V, ± 5% 

Overvoltage 

protection +7.5 V / -5 V 

either transmission line to GND. 

Weight approx. 0.150 kg