Kongsberg C-series cutting machine troubleshooting guide

Check the tension of the conveyor belt: observe whether the green markings on both sides are within the scale range. If there is a deviation, professional adjustment is required.

Clean the blocking hole of the vacuum table (without conveyor belt model): Use a 0.5-0.6mm steel needle to pass through the hole.

7.4 Quarterly/Semi Annual

Replace the coolant of the cooler (if it is a mixed coolant, supplement it at a concentration of 25%).

Check the wear of the HPMU spindle clamp and replace it if necessary.

Clean the front glass of the bottom camera (USC): Use a microfiber dust removal rod to check if the black tape on the anti warping strip is intact.