Triconex Tricon™ v9–v11 Systems Planning and Installation Guide

（2） Power module: Stable power supply guarantee

Model Input Voltage Range Output Parameters Key Characteristics Adaptation Scenarios

8310 120VAC/VDC (± 15%) output voltage 6.5VDC ± 1%; Output current 27A; output power 175W (60 ℃); input frequency 47-63Hz; built-in 5A delay fuse; Supports overvoltage (115% threshold), overcurrent (135% threshold), and over temperature protection; Alarm contact point (NO/NC/C) in North America, with input of 120VAC/VDC scenario

8311 24VDC (19.2-36VDC) output voltage 6.5VDC ± 1%; Output current 27A; output power 175W (60 ℃) reverse polarity protection; Built in 15A delay fuse (non removable); Support low battery alarm (battery backup); Compliant with ATEX certification requirements for global use, with an input of 24VDC scenario

8312 230VAC (± 15%) output voltage 6.5VDC ± 1%; Output current 27A; output power 175W (60 ℃), input frequency 47-63Hz; built-in 2.5A delay fuse; ATEX scenario not supported in Europe, input as 230VAC scenario

Common supplement: Dual redundant configuration, two power modules working simultaneously, load sharing; A single module can independently support the full load operation of the entire machine; The power module comes with PASS (normal), FAILT (fault), TEMP (overheating), BATT LOW (low battery level) indicator lights; The power module of the host rack contains dual redundant lithium batteries, which provide 6-month data backup for the processor RAM (in case of power failure).

（3） Main Processor (MP): System Computing and Control Core

Model compatibility, system version, core configuration, key performance parameters, functional characteristics

3006/3007 v9.0-9.5. x main processor: National NS32GX32 (32-bit, 25MHz); Coprocessor: NS32381 (floating point); EPROM 512KB； SRAM 2MB（3006）/1MB（3007）； DRAM without TriBus speed of 4Mbps; Serial port speed 9600bps; Clock drift ± 2-8.6 seconds/day; Logic power consumption of 15W supports basic control functions, without Ethernet interface; Suitable for early v9 systems

3008 v9.6-10. x main processor: Motorola MPC860 (32-bit, 50MHz); DRAM 16MB (without battery backup); SRAM 32KB (battery backup); Flash PROM 6MB TriBus speed 25Mbps; Ethernet interface (RJ-45, reserved); Serial port speed 9600bps; Clock drift ± 2-2.16 seconds/day; Logic power consumption of 10W supports event sequence (SOE) recording; Compatible with more communication modules

3009 v11. x main processor: QorlQ P1021 (dual core, 800MHz); 256MB DRAM (without battery backup); SRAM 2MB (battery backup); Flash PROM 128MB TriBus speed 1000Mbps (8120E rack)/25Mbps (8110 rack); USB interface (reserved); Serial port speed 115200bps; Clock drift ± 2-2.16 seconds/day; Logic power consumption of 14W supports high-speed communication and OPC UA protocol; Adapt to enhanced mainframe

Common supplement: The three processor modules (A/B/C) must have the same model and execute control programs synchronously; Implementing data synchronization, voting, and fault isolation through TriBus; Support sequence event recording (SOE) with timestamp accuracy of 1 microsecond; Built in diagnostic circuit that can detect processor, memory, and TriBus communication faults.

（4） Communication module: Cross system interconnection core (supplementary protocols and rates)

Module Type Model Core Interface Supports Protocol/Rate Adaptation Scenarios

TCM 4351B/4352B/4353/4354 4 serial ports (RS-232/485), 2 Ethernet ports (RJ-45/fiber), 1 debugging port serial port: Modbus RTU/ASCII (rate 115.2Kbps); Ethernet: Modbus TCP, OPC DA/A&E (4353/4354), TCP/IP, SNTP; Aggregate speed of 460.8Kbps for connecting Modbus devices, OPC clients, and Ethernet hosts; Compatible with v10.3-11. x systems

UCM 4610 has 2 serial ports (RS-232/485), 4 fiber optic Ethernet ports, 1 infrared port, and 1 timing port. Serial port: Modbus (speed 115Kbps); Ethernet: Modbus TCP, TCP/IP, TSAA; Support the integration of Foxboro Evo system with large-scale factory Foxboro DCS interconnection scenarios; Adapt to v11. x system

EICM 4119/4119A 4 serial ports (RS-232/485), 1 parallel printing port serial port: Modbus RTU/ASCII (speed 19.2Kbps), TriStation communication; Aggregate rate of 57.6Kbps for connecting Modbus devices and printers; Compatible with v10. x and previous systems

NCM 4329/4329G 2 Ethernet ports (BNC), 1 serial port (reserved) Ethernet: Peer to Peer (10Mbps), TriStation communication; NCMG supports GPS timing with multiple Tricon controllers for interconnection and time synchronization; Compatible with v10. x and previous systems

SMM 4409 2 UCN ports (F-type connector), 1 debugging port UCN protocol (5Mbps); Support Honeywell TDC-3000 DCS docking; Support event sequence transmission and Honeywell DCS interconnection scenarios; Adapt to v9-11. x system

（5） I/O module: signal input/output core (with additional details such as precision and response time)

1. Digital Input Module (DI)

Model, Voltage, Specification, Number of Points, Type, Key Parameters, Core Characteristics

3501E/T 115VAC/VDC 32 TMR switch threshold: On → 69V (typical)/86V (maximum), Off → 36V (typical)/28V (minimum); Input delay<8ms (On → Off)/<15ms (Off → On); Input impedance>8.5k Ω optical isolation (1000VAC/1500VDC); Non common land design; Supports overvoltage protection (150VDC/115VAC)