LTI Drives LSH-127-3-30-560 Servo Motor
Product Overview
The LTI Drives LSH-127-3-30-560 is identified as an industrial servo motor with the reference number 11714056. The supplied product designation lists a rotational speed of 3000 revolutions per minute, a voltage marking of 560V and a current marking of 13.13A. These values should be checked against the physical nameplate and the documentation for the exact motor variant before they are used for electrical design or equipment selection.
Servo motors are designed to operate as part of a controlled motion system. Unlike a motor selected only for basic continuous rotation, a servo motor is typically paired with a compatible drive controller and, where required, a feedback device. The controller regulates motor operation according to the selected control mode, command signals and configured motor parameters.
Motor Control and Performance
The motor's suitability for a particular application depends on more than its nominal speed and electrical markings. Important engineering factors include rated torque, peak torque, speed range, inertia, thermal behavior, feedback type, shaft arrangement and permitted operating duty. These values must be obtained from the technical data for the exact LSH motor variant rather than estimated from the model code.
In a correctly configured system, a compatible drive can regulate motor speed and coordinate motion with the rest of the machine. The required performance depends on the mechanical load, acceleration and deceleration profile, mounting arrangement and control architecture.
Industrial Applications
Industrial servo motors are commonly used in machinery requiring controlled movement and repeatable positioning. Potential applications include automated production equipment, machine tools, material handling, assembly systems and specialized manufacturing machinery. The LSH-127-3-30-560 should only be selected for an application after its torque, speed, thermal and feedback requirements have been matched to the load and drive controller.
Drive Compatibility
Before integrating the motor, verify the supported motor type, voltage range, current requirements and feedback interface of the intended drive. Confirm that the controller can provide the required continuous and peak operating performance. Incorrect motor data or feedback configuration can cause poor control response, drive faults or unexpected movement.
The motor cable, feedback cable, shielding and protective earthing must follow the drive manufacturer's wiring instructions. Cable routing should account for electromagnetic interference and separation between power and signal wiring.
Installation and Commissioning
Mechanical installation requires a suitable mounting surface, correct shaft alignment and a coupling appropriate to the application. Avoid transmitting unintended radial or axial loads to the shaft. Verify that the driven mechanism can move safely through its required travel and that guards and protective devices are installed.
Before enabling the system, check the nameplate data, feedback signals, motor phase connections and configured operating limits. Initial motion tests should be performed under controlled conditions. The listed 560V and 13.13A values must not be used as a substitute for checking the complete electrical specification and the drive manufacturer's requirements.
Maintenance and Identification
Routine inspection may include checking connectors, cables, mounting bolts, shaft coupling, abnormal noise and temperature. Any unusual vibration or repeated drive fault should be investigated before the equipment returns to normal service. When ordering a replacement, record the complete LSH-127-3-30-560 designation and identification number 11714056.
The LTI Drives LSH-127-3-30-560 servo motor is a component of an industrial motion control system. Correct motor and drive matching, careful installation and accurate configuration are essential to reliable performance.
