Welcome to the Industrial Automation website!

NameDescriptionContent
XING-Automation
E-mail  
Password  
  
Forgot password?
  Register
当前位置:

The concept of "Level 4" sewage treatment was first introduced in the European Municipal Sewage Treatment Guidelines

F: | Au:佚名 | DA:2023-12-20 | 747 Br: | 🔊 点击朗读正文 ❚❚ ▶ | Share:

The European Parliament has published a revised draft of the new Municipal sewage Treatment Guidelines (UWWTD 91/271) : adding nutrient recovery targets and tightening the requirements for phosphorus discharge from sewage treatment plants. The draft is now before the European Parliament and the Council for discussion.

The guidelines are clear and simple and have been successful in improving water quality. Among them, the revised guidance identifies new pollutants, storm overflows and dispersed rural emissions to ensure that proposed solutions are consistent with green policy climate, biomethane production and circular economy objectives. Better recovery of nitrogen, phosphorus and other organic matter is tentatively planned for the period up to 2040.

The European Parliament estimates that this new regulation will lead to an increase in water prices of about 2.3%.

The proposed changes to the existing guidance include:

· Stricter emission limits for phosphorus and nitrogen (Appendix I) :

- 0.5 mg TP/L or 90% phosphorus removal rate (previously 1~2 mg/L or 80% removal rate);

- 6 mg N/L or 85% nitrogen removal rate (previously 10 to 15 mg/L or 70% to 80% removal rate);

- These limits are the same as the previous regulations and apply to wastewater treatment plants in eutrophication areas of > 10,000 population equivalent. However, additional provisions are also applicable to sewage treatment plants in non-eutrophically-sensitive areas > 100,000 population equivalent;

- The concept of non-eutrophication sensitive area is discarded (it was basically not processed before).

· The European Parliament will authorize the adoption of a bill to undertake a delegated act on minimum phosphorus and nitrogen utilization and recycling rates in sludge (Article 20)

ESPP notes:

- Nutrients may include organic carbon, but are in fact limited to N and P in the Act;

- The wording "utilization rate and recycling rate" should include the agricultural value-added part of agricultural sludge;

- Wording "minimum... "Rate" refers to the N and P in the sludge, not the nutrients that flow into the sewage treatment plant, which is not the same thing for N. Wastewater treatment plant P and N recycling are completely different. This does not take into account nutrients recovered at source, such as urine separation.

Wastewater treatment plants must be "energy neutral" by 2040. Energy neutralization is defined as "the total amount of renewable energy produced by a wastewater treatment plant" in quantity consistent with the total amount of energy consumed. Renewable energy here refers to the total amount of energy in the country, not each sewage treatment plant

ESPP note: This is very different from climate neutrality in that it does not take into account NOx, N2O and CH4 emissions from wastewater treatment plants, carbon emissions from sludge pipe disposal outside wastewater treatment plants, the climate impact of nutrient recovery (alternative fertilizers), and carbon sequestration of sludge back to field. The idea now is to sequester sewage and sludge on land. Indeed, such a phrase could simply mean that the installation of a number of wind turbines in a sewage treatment plant would seem to be sufficient.

· Collection and treatment of sewage from all concentrations > 1,000 population equivalent (originally 2,000 population equivalent) (Articles 3.2, and 6.2)

Introduction of a new concept of "Quaternary treatment" (Article 8 and Appendix I)

This requires the removal of at least 80% of indicative organic pollutants. Such treatment is required for all sewage treatment plants > 100,000 population equivalent and for all sewage treatment plants > 10,000 population equivalent that are identified as being at risk of pollution or discharging into swimming contact waters.

Extended Producer Responsibility (EPR) applies only to pharmaceuticals and cosmetics. In this way, the companies producing these products must bear the full cost of monitoring and level 4 treatment (Article 9 and Appendix III).

ESPP Note: Extended producer responsibility does not cover industrial chemicals such as PFAS and plastic additives, nor does it cover agricultural chemicals.

The European Commission will develop a method for measuring microplastics in sewage and sludge, which must then be monitored in sewage treatment plants of > 10,000 population equivalent (Article 21).

· Promote reuse of reclaimed water (Article 15)

· The new concept of "Integrated Municipal Wastewater Management Plan" is mandatory for all municipalities with a population equivalent of > 100,000 and for municipalities with a population equivalent of > 10,000 where stormwater or municipal runoff meets certain conditions (Article 5 and Appendix V)

· Redefine "sludge", "micropollutants" and "microbial resistance" (Article 2)

Note: The above obligation is the final requirement of the proposal. In some cases, the intermediate level is fixed for certain date ranges. References to articles/attachments refer to published revised proposals (not those in the existing 1991 guidelines). The above is a simplified interpretation in many cases, please refer to the published regulatory proposals for details.

  • Sigmatek MDD111-1 DIAS Drive Axis Module
  • Sigmatek DKL042 05-024-042 Terminal Module
  • Sigmatek DM822 Control Module
  • Sigmatek CDM167 12-008-167-O Module
  • Sigmatek TAE151 Touch Display Unit
  • Sigmatek DCC041 SLIDES Module 05-700-041-D
  • Sigmatek AKM65M-ANC2GBB0 PM Servo Motor
  • Sigmatek ETT221 01-230-221 Operator Terminal
  • Sigmatek SLIDES DAM 124 Analog Module
  • Sigmatek AKM31C-ANCNGBB0 Servo Motor
  • Mannesmann Demag Sigmatek CP626 Central Unit
  • SIGMATEK 0332.554.03 Board 371071000154
  • SIGMATEK 12-250-021 Base Plate Back Panel CM5V020
  • SIGMATEK DM162 S-DIAS Digital Mix Module
  • DEMAG ERGOTECH 061 381 66 Sigmatek 9842.243.02 Circuit Board
  • SIGMATEK CP313-1 PLC Module
  • Sigmatek ETV0551-2 VARAN Touch Terminal
  • Sigmatek SDM 081 FS S-Dias Safety Module
  • DEMAG 05-250-023 Ergotech Motherboard with Sigmatek TMS012
  • Sigmatek CM5V020 12-250-023-K Wiring Base
  • Sigma Tek 5000B-37 Attitude Gyro Indicator
  • Sigmatek SDD120-2 DIAS Drive
  • Sigmatek CME221 Memory Module
  • Sigmatek DCP640 DIAS Central Unit
  • Sigmatek STO040 Safety Output Module
  • Sigmatek CET281 Control Panel
  • Sigmatek CIPC LX800 Demag NC5 CPU
  • Sigmatek DKL093 05-024-093 Terminal Module
  • Sigmatek AI088 20-009-088 Analog Input Module
  • Sigmatek CAI888 Analog Input Module
  • SIGMATEK CCA021 12-025-021 Analog Output Module
  • SIGMATEK 1104.579.05 Control Module
  • SIGMATEK SDI100 Digital Input Module
  • SIGMATEK C-IPC 256MB LX800 Compact Dias
  • SIGMATEK 9423.090.02 Control Module
  • SIGMATEK C-IPC 256 Power Supply 148498
  • SIGMATEK CAI025 Analog Input Module
  • SIGMATEK CTO166 Digital Output Module
  • SIGMATEK CP112 20-004-112 Processor Module
  • SIGMATEK CAI887 12-009-887 Safety Module
  • Sigma-Tek 4000B-31 Directional Gyro 1U262-002-42
  • Sigmatek C-IPC 256MB LX800 IPC Controller
  • Sigmatek C-IPC 01-450-031 Industrial PC LX800
  • Sigmatek C-IPC 256 Industrial PC Controller
  • Sigmatek CCP-531 PLC Processor Module
  • Sigmatek CDI163 Digital Input Module
  • Sigmatek ETV0501 VARAN Terminal 12-230-0501
  • Sigmatek CTMS020 C-DIAS Technology Module
  • Sigmatek CIV512 VARAN Switch Module
  • Sigmatek HU011 20-080-011 Interface Module
  • SIGMATEK SLIDES DAM 124 Module
  • SIGMATEK C-IPC 161 01-450-161L Industrial PC
  • SIGMATEK C-IPC 128MB VIA 733MHz 01-450-024-K
  • SIGMATEK 12-780-012 R8-IPC Geode LX800 Module
  • SIGMATEK CAM124 Analog Module
  • SIGMATEK S1 032-8AF61-R4 EZ Servo Motor
  • SIGMATEK CTO163 Digital Output Module
  • SIGMATEK CCP082 12-004-082 Processor Module
  • SIGMATEK CRCH081 C-DIAS Temperature Module
  • SIGMATEK PC322-K 01-310-322-K Industrial PC
  • SIGMATEK SDD310-2 Servo Drive
  • SIGMATEK AI084 Analog Input Module
  • SIGMATEK CRCH081 12-752-081 Temperature Module
  • Sigma-Tek 5000L-4 Attitude Gyro 1U284-001-3
  • SIGMATEK CM5V020 12-250-023-K Wiring Module
  • Sigma-Tek 4000H-6 Directional Gyro IU262-035-7
  • SIGMATEK Dias DCP160 05-004-160 Processor Module
  • SIGMATEK 0147.395.02 Control Module
  • SIGMATEK A1084 Control Module
  • SIGMATEK DI200 20-006-2000 Digital Input Module
  • Sigmatek DNC115 Encoder Module
  • Sigmatek DAM122 05-017-122 Analog Module
  • Sigmatek 9802.289.01 Control Board TA71 Display
  • Sigmatek TO127 20-007-127 Digital Output Module
  • Sigmatek DNC031 05-011-031 Digital Module
  • Sigmatek VI022 20-003-022 Interface Module
  • Sigmatek CAI085 Analog Input Module
  • Sigmatek CP111 S-DIAS CPU Module
  • Sigmatek CTMS030 Krauss Maffei Module
  • Sigmatek CAM123 Control Module
  • Sigmatek TAE732-P 01-240-732-P Touch Display Unit
  • Sigmatek MDM021 Digital Mixed Module
  • Sigmatek DCP642 DIAS Central Unit
  • Sigmatek CST022 12-014-022 C-DIAS Module
  • Sigmatek SRO021 20-893-021 Safety Relay Output
  • Krauss Maffei MC5 Control System Sigmatek
  • Sigmatek DC061 Module 18-24VDC 300mA
  • Herrmann EVT0855 Ultrasonic Welder Touch Panel
  • Sigmatek CIV521 Control Module 1.4A 2W
  • Sigmatek DDI61 05-006-161 Digital Input Module
  • SIGMATEK ETT312-E Touch Terminal 01-230-312
  • Cessna S3326-1 Sigma Tek 5000B-67 Gyro 1U149-015-9
  • SIGMATEK PS101 Power Supply Module
  • SIGMATEK 0332.554.03 Control Module 371071000154
  • SIGMATEK ETT312-E Touch Terminal 01-230-312
  • SIGMATEK CDM163 Control Module
  • SIGMATEK VSV046 16-023-046 Module
  • SIGMATEK AM221 20-017-221 Analog Module
  • SIGMATEK CTS051 12-053-051 Control Module
  • SIGMATEK AM221 20-017-221 Analog Module
  • Sigmatek CSDI161 12-891-161 Safety Input Module
  • Sigma Tek 4000C-1 Directional Gyro Indicator
  • Sigmatek ETV0501 12-230-0501 VARAN Terminal
  • Sigmatek DDM165 SLIDES Module
  • Sigmatek N100 20-011-100 Control Module
  • Sigmatek AKM54K-ANC2R-B0 PM Servo Motor
  • Sigmatek CTO166 Digital Output Module
  • Sigmatek CP212-K 20-004-212-K CPU Module
  • Sigmatek CDI161 Digital Input Module
  • Sigmatek DCC080 05-700-080-2 Control Module
  • SIGMATEK SCP011 S-DIAS Safety CPU
  • SIGMATEK SCP011 S-DIAS Safety CPU
  • SIGMATEK SRO022 Relay Output Module
  • SIGMATEK MDD 121 Drive Axis Module
  • SIGMATEK DSI021 SLIDES Siemens Interface
  • SIGMATEK DIAS DCP161 Module 05-004-161
  • Sigmatek ETT312 Built-in Touch Terminal
  • SIGMATEK DCP 643 DIAS Controller System
  • SIGMATEK CIO021 Multi I/O Module
  • SIGMATEK CTMS020 Control Module
  • Sigmatek CME 221 Memory Module
  • Sigmatek 0420.615.01 Control Board
  • Sigmatek CP111 20-004-111 CPU Module
  • Sigmatek 9405.065.03 Control Board
  • Sigmatek ETEK 01-450-032-K C-IPC 256MB Industrial PC
  • Sigmatek CTO163 12-007-163 Safety Output Module
  • Sigmatek TO081 20-007-081 Digital Output Module
  • Sigmatek SI021 20-022-021 Safety Input Module