ABB ACS850-04-387A-5

Products Drives Low voltage AC drives Machinery drives

General Information

Global Commercial Alias: ACS850-04-387A-5

Product ID: 3AUA0000089794

ABB Type Designation: ACS850-04-387A-5

Catalog Description: ACS850-04-387A-5 PN:200kW, IN:387A

Ordering

Country of Origin: Finland (FI)

Customs Tariff Number: 85044088

Invoice Description: ACS850-04-387A-5 PN:200kW, IN:387A

Made To Order: Yes

Minimum Order Quantity: 1 piece

Order Multiple: 1 piece

Quote Only: No

Selling Unit of Measure: piece

Stocked At (Warehouses): FIPSEEXPU

US Drive Services

SGRDC002EXPU

CNIAB001EXPU

SGIND002EXPU

AUABB024EXPU

Dimensions

Product Net Height: 1462 mm

Product Net Length: 505 mm

Product Net Weight: 161 kg

Product Net Width: 305 mm

Technical

Enclosure Class: IP00

Frequency (f): 50 ... 60 Hz

Input Voltage (U ): 400 ... 500 V

Mounting Type: Module for cabinet assembly

Number of Phases: 3

Output Current, Heavy-Duty Use: 300 A

Output Current, Light-Overload

Use:

377 A

Products Drives Low voltage AC drives Machinery drives

in

Output Current, Normal Use: 387 A

Output Power, Heavy-Duty Use: 160 kW

Output Power, Light-Overload

Use:

200 kW

Output Power, Normal Use: 200 kW

Additional Information

Product Main Type: ACS850-04-387A-5

Product Name: Frequency Converter

Classifications

ProductSeries: ACS850-04

Removing the cover assembly of the external control unit

The cover assembly needs to be removed before the installation of optional modules

and the connection of control cabling. Follow this procedure to remove the cover

assembly. The numbers refer to the illustrations below.

1. Press the tab slightly with a screwdriver.

2. Slide the lower cover plate slightly downwards and pull it out.

3. Disconnect the panel cable if present.

4. Remove the fastening screw at the top of the cover assembly.

5. Carefully pull the lower part of the base outwards by the two tabs.

6. Refit the cover in reverse order to the above when the control cables have been

connected.

Drive-to-drive link (XD2D)

The drive-to-drive link is a daisy-chained RS-485 transmission line that allows basic

master/follower communication with one master drive and multiple followers.

Termination activation jumper T (see section Jumpers above) next to this terminal

block must be set to the ON position on the drives at the ends of the drive-to-drive

link. On intermediate drives, the jumper must be set to the OFF position.

Shielded twisted-pair cable (~100 ohm, for example PROFIBUS-compatible cable)

must be used for the wiring. For best immunity, high quality cable is recommended.

The cable should be kept as short as possible; the maximum length of the link is

100 meters (328 ft). Unnecessary loops and running the cable near power cables

(such as motor cables) must be avoided. The cable shields must to be grounded to

the control cable clamp plate on the drive as shown on page 102.

The following diagram shows the wiring of the drive-to-drive link.