DS3820LT4A1C1A | General Electric Lod Trak IV Control Panel Mark IV

DS3820LT4A1C1A | General Electric Lod Trak IV Control Panel Mark IV

Product Description P/N: DS3820LT4A1C1A DESCRIPTION / SPECIFICATIONS Description The DS3820LT4A1C1A is a Lod Trak IV Control Panel designed for the Mark IV system. This control panel is part of the Speedtronic Mark IV series from General Electric. It serves as a user interface for system monitoring and control. The panel integrates with the Mark IV control system and includes various input/output interfaces and control elements specific to its application within the industrial control environment. 

 Technical Specifications Condition New / Never Used Surplus Part Number DS3820LT4A.1C1A Category Controls & Indicators Subcategory Control Weight 6.00 lbs Controller Module LoadTrak IV Control Pad Included Power Requirements 5 VDC, 8 AMPS Relay Channels 12 Supply Voltage 24 VDC Information About DS3820LT4A1C1A The DS3820LT4A1C1A is a LoadTrak IV module produced by General Electric, specifically designed for integration within the Mark IV Speedtronic control systems. The Mark IV systems are employed for managing industrial gas and steam turbines, providing comprehensive control and protection functionalities.

 This module is characterized as a multi-function protective unit offering a range of protective features, including overload and overtemperature protection, instantaneous overcurrent detection, jam protection, phase reversal detection, ground fault monitoring, bearing overtemperature monitoring, and phase unbalance detection. The unit is equipped to measure all motor resistance temperature detectors (RTDs) via its internal relay. The embedded microprocessor in the DS3820LT4A1C1A enables users to input motor data and configure trip values, facilitating the adjustment of various protective settings. The DS3820LT4A1C1A includes a terminal board mounted at its rear for the purpose of connecting external components. This facilitates integration with other system elements and allows for wiring connections.

 Manufacturer information General Electric (GE) is a multinational conglomerate founded in 1892, based in the United States. It operates in various industries, including aviation, healthcare, renewable energy, and power. GE is known for its innovations in technology, manufacturing, and infrastructure solutions. IQElectro is not an authorized distributor. QElectro LLC (IQElectro) is NOT an Authorized Distributor or in any way affiliated with Rockwell Automation, Siemens, or any other Manufacturers. IQElectro is NOT an Authorized Dealer of this product. The product may be of older version, date codes, or design than that available from authorized dealers. As IQElectro is not an authorized dealer of this product, the Original Manufacturer's Warranty and Support DO NOT apply.IQElectro sells SURPLUS onlyand DOES NOT SELL SOFTWARE or FIRMWARE licenses For more detailed information, please refer to the full version of our disclaimer policy Disclaimer Policy.

Features 

 Single-Slot Module 

 SNP/SNP-X Protocol (master, slave) 

 CCM Protocol (master, slave, peer) 

 RTU Modbus Protocol (slave only) 

 Supports connection to MS-DOS or Windows

 programming and configuration software package (monitor only) 

 12 Mhz, 80C186 Microprocessor 

 Two RS-422/RS-485 or RS-232 Serial Ports 

 CCM, RTU and SNP/SNP-X Available on Either or Both Ports 

 Simultaneous Communications on Both Ports (up to 9.6 Kbps, or 19.2 Kbps individually) 

 High Performance Access to PLC Memory 

 Three Status LEDs 

 Reset pushbutton 

 Soft Switch Configuration (no switches or jumpers) 

 No Battery Required