GE DS200UCPBG7A PC Board

GE DS200UCPBG7A PC Board

Part Number DS200UCPBG7A Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockGeneral Electric Speedtronic Mark V DS200UCPBG7A is a 486DX4-100 8M DRAM 4M FLASH Board. One CPU and numerous PROM modules are included in the DS200UCPBG7A General Electric PC Board model, as well as a single DIMM connector and one switch block with seven switches. It also has a 34-pin connector as well as a connector for connecting to another board. The 34-pin connector is connected to a ribbon cable inside the drive, and you must connect the ribbon cable to the 34-pin connector on the new board when installing the board. The ID for the 34-pin connector will be the same. It was created as a daughter card to give extra processing and other features. It is connected to other boards through a connection and is held in place by standoffs. The switch block has seven switches that are used to configure the board to fit the site's requirements. These switches are pre-configured in default locations, allowing the board to perform as expected in most applications. The installation documentation that comes with the board describes how the switches modify the board's operation when this is inserted in the drive.

OTHER INFORMATION

• Up to 1.26 GHz Pentium® III processor with 256 KB advanced  transfer cache  

• Up to 512 MB PC-133 SDRAM using a single SODIMM  

• Internal AGP SVGA controller with 4 MB display cache  

• 133 MHz system bus via Intel® 815E chipset  

• Dual Ethernet controllers supporting 10BaseT and 100BaseTX  interfaces  

• Optional PCI dual channel Ultra160 SCSI  

• Up to three (two with rear I/O support) PMC expansion sites  (IEEE-P1386 common mezzanine card standard, 5 V)  

• Up to 1 GB bootable flash on secondary IDE (optional)  

• Two 16-bit and two 32-bit programmable timers  

• 32 KB of nonvolatile SRAM  

• Software-selectable watchdog timer with reset  

• Remote Ethernet booting  

• Optional IDE hard disk drive  

• VME64 modes supported:  A32/A24/D32/D16/D08(EO)/MBLT64/BLT32  

• VMEbus interrupt handler, interrupter and system controller  

• Includes real time endian conversion hardware for littleendian and big-endian data interfacing (patent no. 6,032,212)  

• Enhanced bus error handling  

• Passive heat sink

Instructions and warnings related to the operation of the product:

The following specifications must be strictly observed:

 The technical specifications and typical applications of the product system must be strictly observed.

 PERSONNEL TRAINING: Only trained personnel may install, operate, maintain or repair the product system. These personnel must be instructed on the

These personnel must be instructed and briefed on the conditions in the hazardous area.

 Unauthorised modifications: No modifications or structural changes may be made to the product system.

 Maintenance Responsibility: It must be ensured that the product system is used only under appropriate conditions and in a condition fully suitable for use.

 Working environment: The user must fulfil the specified environmental conditions:

Safety regulations

The following safety regulations must be fully observed when (maintenance) work is carried out on the product system:

1 Disconnect completely.

2 Secure to prevent reconnection.

3 Confirm that the installation has been completed.

4 Perform grounding and short-circuiting.