GE IC693CBL316 Cable, High-Speed RS-232 Programming, 3m Length, Requires Adapter

IC693CBL316 Cable, High-Speed RS-232 Programming, 3m Length, Requires Adapter

Type:RS-232 Cable Length:3 meters Connector Type:Female Required Adapter:110XCA20300 Operating Temperature:-40"C to 85"C Material:High-grade Copper Compatibility:GE Fanuc Automation PLCs Experience seamless RS-232 communication with our GE IC693CBL316 cable, designed for high-speed data transfer in industrial environments. This 3-meter cable ensures reliable connectivity between your GE Fanuc Automation PLCs and external devices. Crafted from high-grade copper, the cable delivers superior electrical conductivity, ensuring minimal signal loss and optimal performance. It  engineered to withstand harsh industrial conditions, maintaining consistent performance across a wide temperature range. 

 For applications requiring extended reach without the need for additional hardware, this cable is an ideal solution. It comes equipped with a female connector, compatible with most industry-standard RS-232 interfaces. To maximize the performance and functionality of your GE Fanuc Automation system, consider using our specially designed adapter, part number 110XCA20300. This adapter ensures compatibility and facilitates smooth integration. Trust GE  commitment to quality and reliability. Our IC693CBL316 cable is backed by comprehensive support and warranty, ensuring peace of mind for your industrial automation projects. The GE IC693CBL316 cable facilitates rapid RS-232 programming over distances up to 3 meters, enhancing system efficiency and connectivity.

Compatibility 

ƒ Compatible with any Series 90-30 CPU except IC693CPU321 and IC693CPU340. Configuration size is limited for CPU311/313/331, as described on the next page. 

ƒ Requires release 8.0 CPU firmware. The latest Release 10 is recommended, if available for the particular CPU. 

ƒ Requires CIMPLICITY Machine Edition Logic Developer PLC version 3.0 plus the appropriate service pack or special (or a version later than 3.0). 

ƒ Not compatible with the VersaPro™, Control, or Logicmaster™ programming software. 

ƒ The Series 90-30 Hand-Held Programmer (IC693PRG300) cannot be used to configure this module. New Features The Series 90-30 DeviceNet Master Module allows a Series 90-30 PLC to send and receive I/O data from a DeviceNet network. 

Module features include: 

ƒ Support for all standard data rates (125K, 250K, 500K) 

ƒ Support for 255 bytes input data transfer and 255 bytes output data transfer per slave 

ƒ Support for 3972 bytes of input data transfer and 3972 bytes of output data transfer per master 

ƒ Support for two I/O connections per Slave - Typically one connection is used for Polled and the other is used for Strobe, Cyclic, or COS 

ƒ Support for Poll, Strobe, Cyclic and COS I/O Connections, Fragmented I/O and Explicit Messaging 

ƒ Support for Unconnected Message Manager (UCMM) with 1 proxy connection per slave device 

ƒ Support for configuration of the global scan rate 

ƒ Support for configuration of update rates for Poll and COS/Cyclic on a connection basis 

ƒ Support for PLC-application initiated explicit messaging via a COMMREQ 

ƒ Master can be configured to operate as a slave simultaneously with master operation 

ƒ Configurable fault behavior on loss of communication 

ƒ Reports loss or reestablishment of communication with slaves in PLC fault table (configurable) 

ƒ Support for 64 network device status bits (note: the bit for the master itself is always zero) 

ƒ Firmware update via service port on module