GE DS3800HXFC CIRCUIT BOARD

GE DS3800HXFC CIRCUIT BOARD

Part Number DS3800HXFC Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockThe DS3800HXFC is a Printed Circuit Board developed by General Electric for the Mark IV series. The Mark IV was created to operate gas or steam turbines. It is based on a network of interconnected microprocessors that monitor the turbine system around the clock. 

Alignment lettering is marked on one edge of the board. This is broken up with triangular marks. The board's corners are drilled, and nylon extractor clips are installed in two of them. Extractors are useful to technicians when working space is limited because the clips can serve as handles for the PCB while also providing a lever point to push against the frame or chassis to pull the board from its position. There are three mating connectors on the board. 

One male vertical pin connector, M83503/24-19 8535 male right-angled connector, and 218A4553-1 Amp 533002-1 8728 multi-pin right-angled connector. It has one toggle switch, three light-emitting diodes, or LEDs (one amber, two red), four test points, and four vertical nylon spacers to support the corners of an optional auxiliary board. There are eight jumper switches on the DS3800HXFC's surface. It consists of six resistor network arrays. On the board, there are over forty circuits. The board includes Octal buffers and line drivers, quad differential line drivers with a 15V input voltage, and a 6k minimum input impedance. Octal tri-state buffers/drivers/receivers with tri-state outputs and PNP inputs and hex/quad D flip-flops with buffered clock and direct clear inputs are all included.

Features 

▪ Contains 10 Mbytes of battery-backed user memory and 10 Mbytes of non-volatile flash user  memory. 

▪ Provides access to bulk memory via reference table %W. 

▪ Configurable data and program memory. 

▪ Programming in Ladder Diagram, C, Structured Text, and Function Block Diagram. 

▪ Supports auto-located Symbolic Variables that can use any amount of user memory. 

▪ Reference table sizes include 32Kbits for discrete %I and %Q and up to 32K words each for  analog %AI and %AQ. 

▪ Supports Series 90-70 discrete and analog I/O, communications, and other modules. For a  list of modules supported, refer to the PACSystems RX7i Installation Manual, GFK-2223. 

▪ Supports all VME modules supported by Series 90-70. 

▪ Supports RX7i data monitoring over the web. Allows a combined total of up to 16 web server  and FTP connections. 

▪ Supports up to 512 program blocks. Maximum size for a block is 128KB. 

▪ Test Edit mode allows you to easily test modifications to a running program. 

▪ Bit-in-word referencing. 

▪ Battery-backed calendar clock. 

▪ In-system upgradeable firmware. 

▪ Three isolated serial ports: an RS-485 serial port, an RS-232 serial port, and an RS-232  Ethernet station manager serial port. 

▪ The embedded Ethernet interface provides: 

- Data exchange using Ethernet Global Data (EGD) 

- TCP/IP communication services using SRTP 

- Support for SRTP Channels, Modbus/TCP Server, and Modbus/TCP Client 

- Full programming and configuration services 

- Comprehensive station management and diagnostic tools 

- Two full-duplex 10BaseT/100BaseT/TX (RJ-45 Connector) ports with an internal network  switch providing auto-negotiated network speed, duplex mode, and crossover detection. 

- User-configurable Redundant IP address 

- Time synchronization to SNTP time server on Ethernet network (when used with  Release 5.00 or later CPU module).