GE IS200TSVCH2A Terminal Board Servor

GE IS200TSVCH2A Terminal Board Servor

Part Number IS200TSVCH2A Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VIe Function Module Availability In StockThe IS200TSVCH2A is a turbine-specific Terminal Board Servor under the speedtronic Mark VI series. This is only one of several types of turbine-specific I/O boards we have in stock, so make sure you get the right one for your needs. This board is a two-channel barrier-type servo terminal board, and it is one of numerous turbine-specific terminal boards available for the system. It's called an I/O module, and it's utilized to make a direct connection between the Speedtronic system and field devices. 

These boards allow users to simplify diagnosis, monitoring, and maintenance of linked field equipment and their connections by reducing or eliminating extraneous instrumentation and connection points. Two coil outputs and two pulse-rate inputs are included. The IS200TSVCH2A is about 2.25 pounds in weight. It is meant to provide a direct interface for actuators and external sensors as a servo-valve terminal board. Using boards like this one, you may simplify or eliminate a lot of the original instrumentation that was previously used between the system and these external components. This decreases the likelihood of single-point failures while increasing system reliability. It also lowers the demand for and cost of long-term maintenance. 

The PCB has two barrier-type terminal blocks that can be removed. These are on one long side of the board. The board has two pulse rate inputs for heavy-duty, aviation gas, and steam applications. This board is meant to be used with a PSVOH1B battery pack. Four transformers, three d-shell connectors, and multiple vertical plug connectors are among the other board components on the IS200TSVCH2A. The board features a number of jumper switches, each of which can be adjusted to one of the numerous options. Components are positioned on both sides of the board with this style. Components are labeled with reference numbers to make identification easy. 

The board has two barrier-type terminal blocks that can be removed. These are on one long side of the board. The board has two pulse rate inputs for heavy-duty, aviation gas, and steam applications. This board is meant to be used with a PSVOH1B battery pack. Four transformers, three d-shell connectors, and multiple vertical plug connectors are among the other board components on the board. The board features a number of jumper switches, each of which can be adjusted to one of the numerous options. Components are positioned on both sides of the board with this style. Components are labeled with reference numbers to make identification easy.

OTHER INFORMATION

• Up to 1.26 GHz Pentium® III processor with 256 KB advanced  transfer cache  

• Up to 512 MB PC-133 SDRAM using a single SODIMM  

• Internal AGP SVGA controller with 4 MB display cache  

• 133 MHz system bus via Intel® 815E chipset  

• Dual Ethernet controllers supporting 10BaseT and 100BaseTX  interfaces  

• Optional PCI dual channel Ultra160 SCSI  

• Up to three (two with rear I/O support) PMC expansion sites  (IEEE-P1386 common mezzanine card standard, 5 V)  

• Up to 1 GB bootable flash on secondary IDE (optional)  

• Two 16-bit and two 32-bit programmable timers  

• 32 KB of nonvolatile SRAM  

• Software-selectable watchdog timer with reset  

• Remote Ethernet booting  

• Optional IDE hard disk drive  

• VME64 modes supported:  A32/A24/D32/D16/D08(EO)/MBLT64/BLT32  

• VMEbus interrupt handler, interrupter and system controller  

• Includes real time endian conversion hardware for littleendian and big-endian data interfacing (patent no. 6,032,212)  

• Enhanced bus error handling  

• Passive heat sink