General Electric DS200TCPDG2B Power Distribution Board For Reliable Mark V Series Control Systems

General Electric DS200TCPDG2B Power Distribution Board For Reliable Mark V Series Control Systems

Manufactured By:General Electric Model:DS200TCPDG2B Category:Power Distribution Board Sub-Category:Mark V Series Module Type:Power Distribution Operating Voltage Range:120V to 480V AC Current Rating:60A Number of Circuit Breakers:36 Number of Toggle Switches:8 Number of Signal Wire Terminals:4 Number of OK LEDs:36 Connector Type:10-pin Operating Temperature Range:-20"C to +55"C The General Electric DS200TCPDG2B Power Distribution Board boasts an advanced design that integrates seamlessly into the Mark V Series, offering unparalleled efficiency and reliability in managing power distribution. Equipped with 8 toggle switches, 36 fuses, and 4 signal wire terminals, this board ensures precise control over various electrical circuits within industrial systems, making it indispensable for complex operations.

 The inclusion of 36 OK LEDs provides a quick visual status check for each fuse, enabling operators to quickly identify and address potential issues without interrupting system operation. With its compact size and robust IP54 rating, the DS200TCPDG2B is ideal for both indoor and outdoor applications, ensuring reliable performance in challenging environments. Certified for safety and quality by UL and CE, this board adheres to the highest industry standards, ensuring peace of mind for users seeking a dependable solution for their power distribution needs. The General Electric DS200TCPDG2B Power Distribution Board is a high-efficiency control module designed for the Mark V series, providing seamless integration and enhanced performance in turbine control systems.  

Compatibility 

ƒ Compatible with any Series 90-30 CPU except IC693CPU321 and IC693CPU340. Configuration size is limited for CPU311/313/331, as described on the next page. 

ƒ Requires release 8.0 CPU firmware. The latest Release 10 is recommended, if available for the particular CPU. 

ƒ Requires CIMPLICITY Machine Edition Logic Developer PLC version 3.0 plus the appropriate service pack or special (or a version later than 3.0). 

ƒ Not compatible with the VersaPro™, Control, or Logicmaster™ programming software. 

ƒ The Series 90-30 Hand-Held Programmer (IC693PRG300) cannot be used to configure this module. New Features The Series 90-30 DeviceNet Master Module allows a Series 90-30 PLC to send and receive I/O data from a DeviceNet network. 

Module features include: 

ƒ Support for all standard data rates (125K, 250K, 500K) 

ƒ Support for 255 bytes input data transfer and 255 bytes output data transfer per slave 

ƒ Support for 3972 bytes of input data transfer and 3972 bytes of output data transfer per master 

ƒ Support for two I/O connections per Slave - Typically one connection is used for Polled and the other is used for Strobe, Cyclic, or COS 

ƒ Support for Poll, Strobe, Cyclic and COS I/O Connections, Fragmented I/O and Explicit Messaging 

ƒ Support for Unconnected Message Manager (UCMM) with 1 proxy connection per slave device 

ƒ Support for configuration of the global scan rate 

ƒ Support for configuration of update rates for Poll and COS/Cyclic on a connection basis 

ƒ Support for PLC-application initiated explicit messaging via a COMMREQ 

ƒ Master can be configured to operate as a slave simultaneously with master operation 

ƒ Configurable fault behavior on loss of communication 

ƒ Reports loss or reestablishment of communication with slaves in PLC fault table (configurable) 

ƒ Support for 64 network device status bits (note: the bit for the master itself is always zero) 

ƒ Firmware update via service port on module