GE VMIVME-3122 High Performance 16 Bit Analog to Digital Converter (ADC)

Common mode rejection: DC to 60 Hz (350 source imbalance), minimum 90 dB, typical 100 dB at gain 1; minimum 100 dB, typical 120 dB at gain 10; minimum 75 dB common mode rejection in the range of ± 2.5 V and 0 to+5 V, adjustable on-site to the same level as gain 1.

Overvoltage protection: continuous ± 35 V (power on/off), transient ± 80 V (maximum 1 second).

Integral nonlinearity: maximum ± 0.005% (compared to the optimal line), differential nonlinearity: ± 0.0015%.

Physical/Environmental Characteristics

Working temperature: 0 to+65 ° C (standard VME slot), storage temperature: -40 to+85 ° C.

Humidity: 0 to 80% relative humidity, no condensation.

Altitude: The working altitude can reach 3000 meters.

Cooling: forced air convection (standard VME slot).

Size: Double height European card (6U) board, 160 × 233.35mm.

Weight: Maximum 700 g.

Input connectors (P3, P4): can be ordered as 96 pin DIN non latch or 64 pin DIN latch.

Power requirement: Maximum 7.0 A at+5 VDC.

Mean Time Between Failures (MTBF): 135900 hours (217F).

UIOC ®  Support and compatibility signal conditioning board

UIOC ®  Support: Used as a monitoring device in UIOC, UIOC is programmed to scan all 64 channels and set to AutoScan mode during initialization. Users can use UCLIO ™ Language settings allow programmable channel gain and command UIOC to retrieve data from any or all channels, creating and storing channel gain and offset correction factors through a menu driven calibration process.

Compatible signal conditioning board

VMIVME-3417A: 16 channel isolated signal conditioning board with optional current loop termination, providing a full-scale input range of ± 5 mV to ± 10 V, and optional two pole low-pass input filter (cut-off frequency 4, 40, or 400 Hz).

VMIVME-3418:8 channel strain gauge and RTD isolation signal conditioning board, providing a full-scale input range of ± 5 mV to ± 10 V, with optional low-pass input filter (cut-off frequency 4, 40, or 400 Hz).

VMIVME-3419:32 channel signal conditioning board, with programmable gain and built-in test (BIT), accepts a full range input range of ± 5 mV to ± 10 V according to the selected gain of the A/D board, optional low-pass filter (cut-off frequency 4, 40, 400 or 4 kHz) and current loop terminal input resistance.