ABB 086345-004 module fast shipping and free shipping

Product series:

Symphony Harmony/INFI 90:

Conductor VMS

Modular Power System l

Modular Power System ll

Modular Power System lll

Modular Power System lV

Bridge Controller

Multi-function Processor

Harmony Area Controller

Harmony Rack l/O

Harmony Block l/o

Harmony with s800 I/O

Harmony Control Network

After-sales service:

1. The key customer base is an important part of the survival and further development of the enterprise. Through the return visit and communication of the key customers, the customer demand is gradually improved and the customer satisfaction is improved

2 Due to human factors (self-disassembly, fall or external impact, etc.), irresistible factors (such as natural disasters, etc.) improper storage (rats, liquid infiltration, etc.) caused by computer failure, not free warranty service.

3 Damage to electronic components such as chips and capacitors due to voltage, or failure or damage caused by use in working environments other than those specified in the product manual (such as excessively low ambient temperature; The environment is too wet or dry; Voltage or current instability, etc.), not free warranty service.

Product model: 

ABB

58921718

protection card

ABB

61320954

Gray Encoder Board

ABB

61353372

protection card

ABB

63911500

Connection board

ABB

64250175

switch fuse

ABB

64581805

switch fuse

ABB

64787039

switch fuse

Product Description:

3.1.2 Adjustment parameters

Pos: 7.8 /Technische Daten / Datenblatt/Aktorik/Stellungsregler/TZIDC / TZIDC-200/Betrieb/Justageparameter @ 10mod_1176214397515_3101.doc @ 77364

The TZIDC positioner has a special function for automatic adjustment

of the parameters.

Additionally, the control parameters can be set automatically (in

adaptive control mode) or manually to optimally adapt them to the

process requirements.

Tolerance band

When reaching the tolerance band the position is considered as

corrected. From this point on, the position is further slowly readjusted

until the dead band is reached. The factory setting for this

parameter is 0.3 %.

Dead band (sensitivity)

When reaching the dead band, the position is held. The factory

setting for this parameter is 0,1 %.

Actuator spring action

Selection of the sensor shaft rotating sense (looking into the open

case), if the valve is moved to the safe position by the actuator spring

(actuator is depressurized via Y1/OUT1).

For double-acting actuators the actuator spring action corresponds to

pressurizing the pneumatic output (OUT2).

Display 0 ... 100 %

Adjusting the display (0 ... 100 %) according to the direction of action

for opening or closing the valve.

Pos: 7.9 /Überschriften/1.1.1/2-spaltig/Betriebsüberwachungsparameter @ 10mod_1176214071453_3101.doc @ 77187