ABB CCR70-P Repeater Module CCR70-P H&B Contronic

ABB CCR70-P Repeater Module CCR70-P H&B Contronic

Basic Information

Model No.: CCR70-P, its corresponding model type is 3bdh000512r1.

Dimensions and weight: Dimensions approx. 20.3cm x 5.1cm x 30.5cm, weight approx. 0.6kg.

Place of origin: Germany and Malta.

Functional features

As repeater module, it is mainly used for signal relay and amplification, which can enhance the signal strength and expand the signal transmission distance, ensuring the reliable transmission of signals over long distances or in complex industrial environments.

It supports F net, coaxial cable 75 ohm, point-to-point communication, etc., which enables efficient data interaction between different devices.

System compatibility

This module belongs to ABB H&B Contronic series, also applies to ABB H&B Melody/Contronic S system, can work with other modules in the same series, together to build a complete industrial automation control system, to meet the diversified industrial control needs.

Application Areas

Widely used in the field of industrial automation, such as chemical, pharmaceutical, oil and gas industries, process control systems, as well as power, metallurgy, water treatment and other industries, automated monitoring and control systems, which can effectively improve the stability and reliability of the system, to ensure the efficient operation of industrial production.

OTHER INFORMATION

• The operator panel is designed for stationary installation on a planar surface, where the following conditions are fulfilled: 

– no high explosive risks 

– no strong magnetic fields 

– no direct sunlight 

– no large, sudden temperature changes 

• Install the operator panel according to the accompanying installation instructions. 

• Ground the operator panel according to the accompanying installation instructions. 

• Only qualified personnel may install the operator panel. 

• Separate the high voltage, signal and supply cables. 

• Make sure that the voltage and polarity of the power source is correct before connecting the operator panel to the power outlet. 

• Peripheral equipment must be appropriate for the application and location. 

• In a Zone 2 environment, this equipment shall be installed in an enclosure that provides a degree of protection not less than IP 54 or greater than IP 65 in accordance with IEC/EN 600079-0. The IP rating of the equipment is limited to the IP rating of the enclosure it is to be installed into. 

• In a Zone 22 environment, this equipment shall be installed in an enclosure that provides a degree of protection not less than IP 64 or greater than IP 65 in accordance with IEC/EN 600079-0. The IP rating of the equipment is limited to the IP rating of the enclosure it is to be installed into.