GE DS200SDCIG2A DC Power Supply and Instrumentation Board

GE DS200SDCIG2A DC Power Supply and Instrumentation Board

Part Number DS200SDCIG2A Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockThe DS200SDCIG2A General Electric DC Power Supply and Instrumentation Board serves as an interface to DC2000 drives. It contains several fuses that you can replace if needed with each fuse having an LED indicator associated with it that is lit when the fuse is blown. The fuse functionality is as follows; one fuse is for the 115 V Power Supply, another for the positive signal Power Supply, a third for the negative signal Power Supply, one for the 15 amp NRX assembly and one for the 10 amp NRX assembly.

The GE DC Power Supply and Instrumentation Board DS200SDCIG2A serves as an interface to DC2000 drives. The DS200SDCIG2A is a static-sensitive device, meaning that any static electricity that builds up in it might cause damage to the board or the drive in which it is installed. There are a few guidelines you can follow that apply to handling the board before you install it. Static electricity can build up in you as well as the device, so try to refrain from walking around before the installation. When you do touch the board, only hold it by the edges and not touch the solder or components and make sure only one person touches the board to limit the exposure to static electricity.

Hardware Tips and Specifications

Now that some of the crucial installation guidelines for this Mark V Series product have been explored, it is possible to discuss the various hardware choices made by this DS200SDCIG2A General Electric product. For starters, this DS200SDCIG2A Power Supply incorporates several Berg-type jumpers into its internal assembly. These jumpers have been included for customization purposes, with each being marked by an individual reference designator of JP. The first jumper in the assembly of this Mark V Series SDCI-abbreviated product is the JP1-labeled jumper, which is responsible for the slaving of this assembly's MD contactor drive hardware output. The second jumper in the assembly of this DS200SDCIG2A Power Supply and Instrumentation Board has the JP2 reference designator label, and controls this Mark V Series product's MA ac contactor drop-out time. The final remaining jumper or customizable hardware switch available to the SDCI PCB is the SW1-labeled jumper, which selects ac line CT burdens relative to their nominal dc output current.

Features 

Single slot CPU 

Provides 1 Mbyte of battery-backed memory in the same slot (up to 512 Kbytes available for use by ladder diagram application program)
Supports floating point calculations 

Up to 12K discrete inputs and outputs (any mix - simplex mode only); 2048 voted discrete inputs, 2048 voted discrete outputs Up to 8K analog inputs (simplex mode only) and 8K analog outputs (simplex mode only); 1024 voted analog inputs 

0.4 microseconds per boolean function 

64 MHz, 80486DX2 microprocessor 

Supports IC660/IC661 I/O (and IC697 I/O in simplex mode only) 

Programmed by MS-DOS, or Windows

 software products running on Windows

 95 or Windows NT

 over Ethernet TCP/IP or through the SNP port. 

Configurable data and program memory 

Battery-backed calendar clock 

Three position operation mode switch 

Password controlled access 

Remote programmer keyswitch memory protection 

Four status LEDs 

Software configuration (No DIP switches or jumpers) 

Reference information inside front door 

In-system upgradable firmware