DS200UPLAG1A | General Electric LAN Power Supply Card

DS200UPLAG1A | General Electric LAN Power Supply Card

Product Description P/N: DS200UPLAG1A DESCRIPTION / SPECIFICATIONS Description The DS200UPLAG1A LAN Power Supply Card by General Electric is designed for use in the Mark V Series of turbine control systems. Technical Specifications Condition New / Never Used Surplus Brand General Electric Category PLCs/Machine Control Part Number DS200UPLAG1A Subcategory PC Board PLC/Add-On Board Product Series Mark V Functional Description LAN Power Supply Circuit Functional Acronym UPLA PCB Coating Style Normal Coating 1st Functional Revision A Information About DS200UPLAG1A The DS200UPLAG1A LAN Power Supply Card from General Electric is part of the Mark V Series of turbine control systems. As typical of Mark V Series PCBs, the DS200UPLAG1A is equipped with numerous components and specifications to ensure robust functionality.

 This board includes two 26-pin connectors, one fuse, a toggle switch, a reset button, and an 8-pin connector. It also features a variety of voltage-limiting components such as rectifiers, capacitors, diodes, and integrated circuits. Additionally, the DS200UPLAG1A is coated with a protective PCB layer that guards against daily wear and tear and provides insulation for its hardware components. The product number reveals further details about the board's specifications: it is part of the Mark V Series, manufactured domestically, and identified with the functional abbreviation UPLA, falling under the Group One Mark V Series product grouping with an A-rated primary functional revision. When installing the DS200UPLAG1A, it is essential to carefully inspect the existing board, noting the cables, jumper settings, and switch positions. Label each cable with its corresponding connector number before disconnecting them. Use a screwdriver to remove the four screws holding the board in place, taking care to avoid damaging the board or other components within the drive. Handle the board by its edges, and place it on a clean, flat surface. 

Remove the replacement board from its static protective bag, noting and replicating the jumper and switch positions from the old board. This ensures seamless integration and functionality within the system. Manufacturer information General Electric (GE) is a multinational conglomerate founded in 1892, based in the United States. It operates in various industries, including aviation, healthcare, renewable energy, and power. GE is known for its innovations in technology, manufacturing, and infrastructure solutions. IQElectro is not an authorized distributor. QElectro LLC (IQElectro) is NOT an Authorized Distributor or in any way affiliated with Rockwell Automation, Siemens, or any other Manufacturers. 

IQElectro is NOT an Authorized Dealer of this product. The product may be of older version, date codes, or design than that available from authorized dealers. As IQElectro is not an authorized dealer of this product, the Original Manufacturer's Warranty and Support DO NOT apply.IQElectro sells SURPLUS onlyand DOES NOT SELL SOFTWARE or FIRMWARE licenses For more detailed information, please refer to the full version of our disclaimer policy Disclaimer Policy.

Instructions and warnings related to the operation of the product:

The following specifications must be strictly observed:

l The technical specifications and typical applications of the product system must be strictly observed.

l PERSONNEL TRAINING: Only trained personnel may install, operate, maintain or repair the product system. These personnel must be instructed on the

Hazardous area conditions must be instructed and explained to these personnel.

l Unauthorised modifications: No modifications or structural changes may be made to the product system.

l Maintenance Responsibility: It must be ensured that the product system is only used under appropriate conditions and in a condition that is fully fit for purpose.

l Working environment: The user must fulfil the specified environmental conditions:

Safety regulations

The following safety regulations must be fully observed when (maintenance) work is carried out on the product system:

1 Disconnect completely.

2 Secure to prevent reconnection.

3 Confirm that the installation has been completed.

4 Perform grounding and short-circuiting.