GE DS3800HPLA Panel Interface Board

GE DS3800HPLA Panel Interface Board

Part Number DS3800HPLA Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockThe GE board DS3800HPLA is a panel interface board that belongs to the GE Mark IV series. The GE Panel Interface Board is intended for simple installation in the drive. Each corner of the board has one hole. Screws can be used to secure the board. The board is equipped with a single 40-pin connector that is embedded in the board. Three red indicator LEDs are also present on the daughter card. 

There are also two sockets for electrically erasable programmable read-only memory (EEPROM) modules, seven jumpers, and two trimmer resistors on the board. The daughter card is connected via the forty-pin connector on the GE Panel Interface Board DS3800HPLA. The daughter card adds functionality to the board as well as features that are not available on the board. A 7-inch ribbon cable is attached to the daughter card. One end of the cable is permanently attached to the daughter card. 

The other end of the cable has a 40-pin connector. You connect the connector to the circuit board. Take care not to put any strain on the ribbon cable. That is, instead of holding the daughter card and pulling the ribbon cable out of the connector, hold the daughter card and pull the ribbon cable out of the connector. Instead, hold the connector with one hand and gently pull it away from the board's connector.

OTHER INFORMATION

• Available with either the 1.1 GHz, 1.6 GHz or 1.8 GHz  Pentium® M processor  

• 1.4 GHz Pentium M processor coming soon  

• Up to 2 Mbyte of advanced L2 cache  

• Up to 1.5 Gbyte DDR SDRAM  

• Up to 2 Gbyte bootable CompactFlash on secondary IDE (see  ordering options)  

• Internal SVGA and DVI controller  

• Serial ATA support through P2 rear I/O  

• 400 MHz system bus via Intel® 855GME chipset  

• Ethernet controller supporting 10BaseT and 100BaseTX  through the front panel  

• Gigabit Ethernet controller supporting 10BaseT, 100BaseTX  and 1000BaseT interface with optional VITA 31.1 support  

• Four asynchronous 16550 compatible serial ports  

• Four Universal Serial Bus (USB) Rev. 2.0 connections, two on  the front panel and two rear I/O  

• PMC expansion site (PCI-X, 66 MHz)  

• 32 Kbyte of nonvolatile SRAM  

• Operating system support for Windows® XP, Windows 2000,  VxWorks®, QNX® , LynxOS® and Linux

Instructions and warnings related to the operation of the product:

The following specifications must be strictly observed:

 The technical specifications and typical applications of the product system must be strictly observed.

 PERSONNEL TRAINING: Only trained personnel may install, operate, maintain or repair the product system. These personnel must be instructed on the

These personnel must be instructed and briefed on the conditions in the hazardous area.

 Unauthorised modifications: No modifications or structural changes may be made to the product system.

 Maintenance Responsibility: It must be ensured that the product system is used only under appropriate conditions and in a condition fully suitable for use.

 Working environment: The user must fulfil the specified environmental conditions:

Safety regulations

The following safety regulations must be fully observed when (maintenance) work is carried out on the product system:

1 Disconnect completely.

2 Secure to prevent reconnection.

3 Confirm that the installation has been completed.

4 Perform grounding and short-circuiting.