GE IC3600AOAK1 IC3600AAMA1G1E Printed circuit board

GE IC3600AOAK1 IC3600AAMA1G1E Printed circuit board

General Information

Manufacturer: GE Fanuc

Series: Mark I-II IC 3600

Type: Printed circuit board

Features

Component Configuration

Potentiometer: It is equipped with one trim potentiometer, which can be used to adjust and calibrate specific parameters of the circuit board.

Transistors and Integrated Circuits: The board is equipped with four transistors and one integrated circuit, which play a key role in signal amplification, switching and other functions.

Resistors: The resistors on the board are mainly carbon composite, which have good stability and resistance characteristics and can effectively control the current and voltage in the circuit.

Capacitors: There are seven large CC capacitors and fifteen small ones. In addition, it contains four polyester vinyl capacitors, which are used for filtering, energy storage and other functions to ensure the stability of the power supply and signal.

Communication Interface: One side of the IC3600AOAK1 is equipped with twenty-five individual metal pins. These pins are used to wire and connect the board into the Speedtronic system, enabling it to communicate with other components and play a role in the overall control system.

Applications

Gas Turbine Management: It is used in GE's Speedtronic gas turbine management system, which can monitor and control the operation of gas turbines, including parameters such as speed, temperature and pressure, to ensure the safe and efficient operation of gas turbines.

Steam Turbine Management: In the steam turbine management system, it helps to realize the regulation and control of the steam turbine's operation, such as adjusting the steam turbine's rotation speed and load, and cooperating with other components to complete the overall control of the steam turbine system.

Instructions and warnings related to the operation of the product:

The following specifications must be strictly observed:

l The technical specifications and typical applications of the product system must be strictly observed.

l PERSONNEL TRAINING: Only trained personnel may install, operate, maintain or repair the product system. These personnel must be instructed on the

Hazardous area conditions must be instructed and explained to these personnel.

l Unauthorised modifications: No modifications or structural changes may be made to the product system.

l Maintenance Responsibility: It must be ensured that the product system is only used under appropriate conditions and in a condition that is fully fit for purpose.

l Working environment: The user must fulfil the specified environmental conditions:

Safety regulations

The following safety regulations must be fully observed when (maintenance) work is carried out on the product system:

1 Disconnect completely.

2 Secure to prevent reconnection.

3 Confirm that the installation has been completed.

4 Perform grounding and short-circuiting.