GE-FANUC IC693MDL231 Isolated Input Module

GE-FANUC IC693MDL231 Isolated Input Module

Number of Inputs:16 Input Voltage Range:24VDC Operating Temperature:-40"C to +70"C Isolation Rating:2000VAC Dimensions:98.5mm x 98.5mm x 26.4mm Weight:0.21kg Protocol Compatibility:Profinet, Ethernet/IP Engineered for industrial strength and reliability, the GE Fanuc IC693MDL231 Isolated Input Module is a key component in your automation system, ensuring precise signal transmission and protection against electrical noise. With its isolated design, this module safeguards against voltage surges, ensuring the longevity and stability of your control system. 

 Featuring a wide operating temperature range (-40"C to +70"C), it  designed to withstand extreme conditions commonly found in industrial settings, from freezing cold workshops to scorching factory floors. Each input channel is equipped with a 10-pin D-sub connector, facilitating easy integration with various sensors and actuators, and ensuring a secure connection for reliable data transfer. Backed by GE Fanuc  commitment to quality and support, this module comes with comprehensive documentation and a manufacturer warranty, providing peace of mind for your automation investment. The GE Fanuc IC693MDL231 Isolated Input Module is designed for seamless integration into industrial automation systems, offering enhanced signal isolation and reliability for continuous operation in harsh environments.

Compatibility 

ƒ Compatible with any Series 90-30 CPU except IC693CPU321 and IC693CPU340. Configuration size is limited for CPU311/313/331, as described on the next page. 

ƒ Requires release 8.0 CPU firmware. The latest Release 10 is recommended, if available for the particular CPU. 

ƒ Requires CIMPLICITY Machine Edition Logic Developer PLC version 3.0 plus the appropriate service pack or special (or a version later than 3.0). 

ƒ Not compatible with the VersaPro™, Control, or Logicmaster™ programming software. 

ƒ The Series 90-30 Hand-Held Programmer (IC693PRG300) cannot be used to configure this module. New Features The Series 90-30 DeviceNet Master Module allows a Series 90-30 PLC to send and receive I/O data from a DeviceNet network. 

Module features include: 

ƒ Support for all standard data rates (125K, 250K, 500K) 

ƒ Support for 255 bytes input data transfer and 255 bytes output data transfer per slave 

ƒ Support for 3972 bytes of input data transfer and 3972 bytes of output data transfer per master 

ƒ Support for two I/O connections per Slave - Typically one connection is used for Polled and the other is used for Strobe, Cyclic, or COS 

ƒ Support for Poll, Strobe, Cyclic and COS I/O Connections, Fragmented I/O and Explicit Messaging 

ƒ Support for Unconnected Message Manager (UCMM) with 1 proxy connection per slave device 

ƒ Support for configuration of the global scan rate 

ƒ Support for configuration of update rates for Poll and COS/Cyclic on a connection basis 

ƒ Support for PLC-application initiated explicit messaging via a COMMREQ 

ƒ Master can be configured to operate as a slave simultaneously with master operation 

ƒ Configurable fault behavior on loss of communication 

ƒ Reports loss or reestablishment of communication with slaves in PLC fault table (configurable) 

ƒ Support for 64 network device status bits (note: the bit for the master itself is always zero) 

ƒ Firmware update via service port on module