GE IS200ISBEH1A ISBus Extender board

GE IS200ISBEH1A ISBus Extender board

Part Number IS200ISBEH1A Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockIS200ISBEH1A is an ISBus Extender Board developed by GE. It is a part of EX2100 excitation system. It is a component of the ISBus High-Speed Synchronous Communication System, designed to enhance communication and control. This board is particularly compatible with the Mark VI series of Speedtronic drive components, which are integral to the control, protection, and monitoring of industrial gas and steam turbines. 

 FEATURES PC-Based HMI Operator Interface: Utilizes a Microsoft Windows platform preloaded with GE CIMPLICITY software, allowing for reinitialization or replacement without impacting other processes. Connection Interface: Typically connects to the J11A interface on the CAPB Control Assembly Backplane board and can also mate with the J12A interface. It features six inputs/outputs located on opposite edges of the board. 

DIN Rail Mounting: The board is designed for mounting on DIN rails, ensuring stability and ease of installation. Optical Performance: Compatible with various I/O component options, including ST-type connected Hard Clad Silica (HCS) fiber or glass fiber connectors. Terminal Strips and Connectors: Includes small terminal strips on each edge, with two plug connectors and two fiber-optic connectors. COMPONENTS AND INDICATORS Conformal Coating: Protects the board components, providing a lightweight and thin layer of protection across the entire board face. 

LED indicators offer valuable information about the drive's functioning status: DS1 is a green LED indicating 24V DC power availability, DS2 is a yellow LED for transmit data input labeled XMIT DATA IN, DS3 is a green LED indicating an active interlock, and DS4 is a green LED indicating correct optical data reception. FUNCTIONAL CAPABILITIES Signal Processing: Converts received optical input data into electrical signals and then reconfigures them into optical output signals. 

Transmit Signal Conditioning: Involves input signal isolation, termination, bypass multiplexing, and electrical-to-optical conversion. Operational Integrity: Maintains its operation without the need for fuses or test points, aside from the customizable hardware jumper.

Features 

 Single-Slot Module 

 SNP/SNP-X Protocol (master, slave) 

 CCM Protocol (master, slave, peer) 

 RTU Modbus Protocol (slave only) 

 Supports connection to MS-DOS or Windows

 programming and configuration software package (monitor only) 

 12 Mhz, 80C186 Microprocessor 

 Two RS-422/RS-485 or RS-232 Serial Ports 

 CCM, RTU and SNP/SNP-X Available on Either or Both Ports 

 Simultaneous Communications on Both Ports (up to 9.6 Kbps, or 19.2 Kbps individually) 

 High Performance Access to PLC Memory 

 Three Status LEDs 

 Reset pushbutton 

 Soft Switch Configuration (no switches or jumpers) 

 No Battery Required

Ease of Use

• Simple and powerful instruction set 

• One-axis or two-axis motion programs with synchronized block start 

• Program support for a short motion program (called Program Zero) which can be created in the MS-DOS programming software configuration function 

• Nonvolatile (flash) storage for 10 programs and 40 subroutines 

• User scaling of programming units (in Standard mode only) 

• Generic programming using command parameters as operands for Acceleration, Velocity, Move and Dwell commands 

• Configured with MS-DOS configuration software