GE IS220PTURH1A Primary Turbine Protection Pack

GE IS220PTURH1A Primary Turbine Protection Pack

Part Number IS220PTURH1A Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VIe Function Module Availability In StockIS220PTURH1A is a Primary Turbine Specific Primary Trip Pack and is part of the General Electric Speedtronic Mark VIe gas turbine control. This component connects a turbine control terminal board to one or two Ethernet networks via an electrical interface. This pack's outputs are routed through a DC-62 pin connection that connects to a terminal board. The IS220PTURH1A has a black outside shell with air circulation holes. This case contains various LED indicators on the front, as well as an IR receiver (infrared port.) This bundle does not use this port. 

A CPU board, a second board dedicated to turbine control, and an analog acquisition auxiliary board are all housed within this case. The TTURH1C terminal board is used to mount the pack. Two 10/100 Ethernet ports, flash memory, RAM, a read-only chip for identification, an internal temperature sensor, and a reset circuit are all on the processor board. Auto-reconfiguration is available on the IS220PTURH1A, which will automatically download from the controller to the I/O pack. Baseload, bootloader, firmware, and settings are all reconfigured. This can only happen if auto-reconfiguration is enabled. 

The Component Editor in the Toolbox ST program can enable or disable this. The IS220PTURH1A features four magnetic speed inputs that are passive. The circuit sensitivity can detect a 2-RPM turning gear speed to see if the turbine has ceased spinning (turbine has stopped.) The pack's median speed signal is used for speed control as well as the principal Overspeed trip signal.

Features 

 Single-Slot Module 

 SNP/SNP-X Protocol (master, slave) 

 CCM Protocol (master, slave, peer) 

 RTU Modbus Protocol (slave only) 

 Supports connection to MS-DOS or Windows

 programming and configuration software package (monitor only) 

 12 Mhz, 80C186 Microprocessor 

 Two RS-422/RS-485 or RS-232 Serial Ports 

 CCM, RTU and SNP/SNP-X Available on Either or Both Ports 

 Simultaneous Communications on Both Ports (up to 9.6 Kbps, or 19.2 Kbps individually) 

 High Performance Access to PLC Memory 

 Three Status LEDs 

 Reset pushbutton 

 Soft Switch Configuration (no switches or jumpers) 

 No Battery Required

Ease of Use

• Simple and powerful instruction set 

• One-axis or two-axis motion programs with synchronized block start 

• Program support for a short motion program (called Program Zero) which can be created in the MS-DOS programming software configuration function 

• Nonvolatile (flash) storage for 10 programs and 40 subroutines 

• User scaling of programming units (in Standard mode only) 

• Generic programming using command parameters as operands for Acceleration, Velocity, Move and Dwell commands 

• Configured with MS-DOS configuration software 

Technical features

Programmability: Users can program and customise the module according to specific application requirements to achieve precise control of industrial processes and improve productivity and product quality.

Integration and compatibility: The module can be seamlessly integrated with other ABB products and solutions to form a unified automation platform. It also has excellent compatibility with other manufacturers' equipment and systems.

High performance and reliability: High-performance hardware and software are used to ensure stable operation and efficient control in industrial environments. With advanced fault detection and diagnostic functions, potential problems can be detected and dealt with in a timely manner, improving the reliability of the system.

Flexibility and expandability: with modular design, it can be flexibly configured and expanded according to actual needs. Whether it is a small or large project, it can be easily integrated into the existing automation system.