GE ds3800ntbe Power Supply Circuit Board

GE ds3800ntbe Power Supply Circuit Board

Part Number ds3800ntbe Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockGE Speedtronic Mark IV DS3800NTBE is a Thermocouple Card as a part of the Mark IV Series. Thermocouples can be found all over the Mark IV system. The RST system, for example, distributes thirteen exhaust thermocouples: four to R, five to S, and four to T. Each of them calculates the median value and sends it back to the RST, implying that the turbine is controlled by thirteen thermocouples under normal operating conditions. 

The DS3800NTBE is marked for alignment and contains two PCB mating connectors on one edge. These are vertical pin mating connectors with the letters JA and JB on them. They're both 28-pin connections. The DS3800NTBE's circuit board contains 48 capacitors. This circuit board is devoid of resistors and diodes. The board has been drilled several times, both along its edge and across the center, but never through the waffle pattern engraved on the top layer. TBA, TBB, TBC, and TBD are the names of the four big thermocouple components that run parallel to the board's short dimension.

Features 

 Single-Slot Module 

 SNP/SNP-X Protocol (master, slave) 

 CCM Protocol (master, slave, peer) 

 RTU Modbus Protocol (slave only) 

 Supports connection to MS-DOS or Windows

 programming and configuration software package (monitor only) 

 12 Mhz, 80C186 Microprocessor 

 Two RS-422/RS-485 or RS-232 Serial Ports 

 CCM, RTU and SNP/SNP-X Available on Either or Both Ports 

 Simultaneous Communications on Both Ports (up to 9.6 Kbps, or 19.2 Kbps individually) 

 High Performance Access to PLC Memory 

 Three Status LEDs 

 Reset pushbutton 

 Soft Switch Configuration (no switches or jumpers) 

 No Battery Required

Ease of Use

• Simple and powerful instruction set 

• One-axis or two-axis motion programs with synchronized block start 

• Program support for a short motion program (called Program Zero) which can be created in the MS-DOS programming software configuration function 

• Nonvolatile (flash) storage for 10 programs and 40 subroutines 

• User scaling of programming units (in Standard mode only) 

• Generic programming using command parameters as operands for Acceleration, Velocity, Move and Dwell commands 

• Configured with MS-DOS configuration software 

Product Features

High performance: adopting high-performance microprocessor and advanced control algorithm, it can realise fast and accurate control and monitoring, and improve production efficiency and product quality.

Modular design: It is convenient for users to configure and expand, which improves the flexibility and maintainability of the system.

Easy Integration: Provide standard communication interface and protocol, which is convenient for users to integrate with other equipments and achieve seamless connection.

High reliability: Made of high-quality materials and advanced technology, it has high reliability and stability, and can operate stably under harsh working environment.

Easy to use: Provides simple interface and easy-to-operate software, which is convenient for users to install and use. At the same time, the module also has a self-diagnostic function, which can help users quickly locate faults and maintenance.

Good scalability: can be seamlessly integrated with other ABB modules and equipment, which is convenient for users to build a large-scale automation control system.