GE CU-AL | General Electric | Trip units and programmers

GE CU-AL | General Electric | Trip units and programmers

Product Description P/N: DS3800NGTA1E1D Description / Specifications Description The DS3800NGTA1E1D by General Electric is a printed circuit board designed for advanced control systems. This precision-engineered board ensures reliable performance in industrial applications, offering efficient signal processing and integration for seamless operation. 

 Technical Specifications Brand General Electric Category PLCs/Machine Control Part Number DS3800NGTA1E1D Subcategory PC Board PLC/Add-On Board Type PC BOARD Information About DS3800NGTA1E1D The DS3800NGTA1E1D is a PCB manufactured by GE to fit into their Mark IV (Speedtronic) series. The Mark IV, which was created for gas and steam turbine control, relies on integrated chipsets built with intentional redundancies to minimize downtown. 

The Mark IV can automate some processes, including startup and shutdown, for more consistent management of the turbine system. Alignment marking has been added to one edge of the DS3800NGTA1E1D. The codes '6DA03' and '6BA04' have been placed on the opposite edge. The board is drilled for mounting. Four nylon pins are inserted in the right quadrant of the board. These support an optional auxiliary board. Near these pins is one of the two communications connectors on the board. This is a multi-pin male vertical connector. The other connector is a female connector located on the left edge. The latter connector is marked 218A4553-1Amp. The DS3800NGTA1E1D has an extractor clip installed in each right corner. 

These clips are designed to aid technicians with the installation and extraction of boards from tight locations. They can be used as handles as needed, which protects the delicate circuitry. They also can lever against case edges and push the board out of place. The DS3800NGTA1E1D has three trim potentiometers and three resistor network arrays. The network arrays may be used for voltage division. It has five TP test points and four LEDs. The board has one toggle switch. The board is built with twenty-five integrated circuits, and various capacitors, resistors (mostly ceramic-covered metal film) and diodes. Manufacturer information General Electric (GE) is a multinational conglomerate founded in 1892, based in the United States. 

It operates in various industries, including aviation, healthcare, renewable energy, and power. GE is known for its innovations in technology, manufacturing, and infrastructure solutions. IQElectro is not an authorized distributor. QElectro LLC (IQElectro) is NOT an Authorized Distributor or in any way affiliated with Rockwell Automation, Siemens, or any other Manufacturers. IQElectro is NOT an Authorized Dealer of this product. The product may be of older version, date codes, or design than that available from authorized dealers. As IQElectro is not an authorized dealer of this product, the Original Manufacturer's Warranty and Support DO NOT apply.IQElectro sells SURPLUS onlyand DOES NOT SELL SOFTWARE or FIRMWARE licenses For more detailed information, please refer to the full version of our disclaimer policy Disclaimer Policy.

Features 

 Single slot CPU 

 Provides 1 Mbyte of battery-backed memory in the same slot (up to 512 Kbytes available for use by ladder diagram application program)  Supports floating point calculations 

 Up to 12K discrete inputs and outputs (any mix - simplex mode only); 2048 voted discrete inputs, 2048 voted discrete outputs Up to 8K analog inputs (simplex mode only) and 8K analog outputs (simplex mode only); 1024 voted analog inputs 

 0.4 microseconds per boolean function 

 64 MHz, 80486DX2 microprocessor 

 Supports IC660/IC661 I/O (and IC697 I/O in simplex mode only) 

 Programmed by MS-DOS, or Windows

 software products running on Windows

 95 or Windows NT

 over Ethernet TCP/IP or through the SNP port. 

 Configurable data and program memory 

 Battery-backed calendar clock 

 Three position operation mode switch 

 Password controlled access 

 Remote programmer keyswitch memory protection 

 Four status LEDs 

 Software configuration (No DIP switches or jumpers) 

 Reference information inside front door 

 In-system upgradable firmware