DDSCR-GL60V_YASKAWA MEMOCON-SC CPU

DDSCR-GL60V_YASKAWA MEMOCON-SC CPU

Basic Product Information

Brand and Model: Yaskawa / DDSCR-GL60V

Series: MEMOCON-SC

Type: CPU Module

FEATURES

Internal Plant Transmission System

Compatible with MEMOCON-SC Systems

Designed to be Used as Single Master Unit

Product Features and Specifications

Although information on the specific specifications of the DDSCR-GL60V is more limited directly, based on the specifications of similar products (e.g., the DDSCR-GL60S2), we can surmise that the DDSCR-GL60V may have the following features:

Structure form: modular, easy to install and replace.

Installation method: Field installation, adaptable to a variety of industrial environments.

LD Instruction Processor: Possibly soft PLC technology to support complex logic control.

I/O points: may belong to medium-sized range, such as 256~2048 points, the specific points need to be confirmed according to the product manual.

Functions: Powerful, able to meet complex industrial control needs.

Operating voltage: usually 220V (specific voltage level should be confirmed according to the product manual).

Parameters such as output frequency, processing speed, programme capacity, data capacity, etc., again need to refer to the specific product manual or technical specification.

Receiving

Please check these items after receiving the drive: 

• Examine the drive for damage. Immediately contact the shipping company if the drive is damaged. The Yaskawa warranty does not cover damage from shipping. 

• Verify the drive model number in the "MODEL" section of the drive nameplate to make sure that you received the correct model. 

• Contact your supplier if you receive the incorrect drive model or if the drive does not operate correctly

Start-Up Procedure

1. Install and wire the drive. 

2. Energize the drive. 

3. Use A1-06 [Application Preset] to initialize the drive for a special application if necessary. 

4. Run the Setup Wizard to automatically set these functions: 

• Control method selection 

• Duty rating selection 

• Monitor parameters 

• Speed reference source 

• Run command source 

• Acceleration and deceleration times 

5. Run the motor without a load. 

6. Make sure that the drive is operating correctly and make sure that the host controller is sending commands to the drive. 

7. Connect the load. 

8. Run the motor. 

9. Make sure that the drive is operating correctly. 

10. Fine-tune and set application parameters, such as PID. 

11. Check final operation and make sure that parameter settings are correct. The drive is prepared to run the operation.