GE DS2020BRCBG2A Brake Control Module

GE DS2020BRCBG2A Brake Control Module

Part Number DS2020BRCBG2A Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockDS2020BRCBG2A is a brake control module designed and developed by GE. It is designed under Drive Control series. Features Input Voltage Rating: 460 VAC Output Voltage Rating: 414 VDC Current Rating: 12.5 AMP The module is constructed with high-quality materials and designed to meet stringent safety standards. It is built to withstand harsh operating conditions and features a compact, robust design that can be easily integrated into machinery or equipment. Board Replacemet Procedure Turn off the drive and wait several minutes for all of the capacitors to discharge. 

Before touching any electrical circuits, make sure the power is turned off. To access the board, open the cabinet door on the drive. Carefully disconnect all cables from the board by doing the following: For ribbon cables, gently pull the cable connector loose by grasping each side of the cable connector that mates with the board connector. Pull the pull tab carefully on cables with pull tabs. Loosen the screw at the top of each terminal and carefully pull each wire free for wires attached to RTB terminals. Remove the board by unscrewing the four screws with washers that secure it to the four standoffs. 

Place all configurable items on the replacement (new) board in the same position as those on the replaced board (old board). Place the new board on the four standoffs using the four screws and washers that were removed in step 4. Reconnect all cables that were disconnected in step 3, making sure that each connector is properly seated at both ends. Reconnect all individual wires that were disconnected in step 3 (as labeled), making sure that each wire is securely fastened in the terminal.

OTHER INFORMATION

• Celeron™ socket 370-based single-board computer (SBC) with operating  system support for Windows NT®/Windows® 2000, Linux, VxWorks, QNX,  and Solaris 

• Special features for embedded applications 

— Up to 512 Mbyte IDE CompactFlash (optional) 

— Three programmable 16-bit timers 

— 32 Kbyte of battery-backed SRAM 

— Remote Ethernet booting supported 

— Software-selectable watchdog timer with reset 

— Supports VMEbus P2 connection to HD/floppy drive 

— PMC expansion site with VMEbus P2 I/O 

— PC•MIP expansion site supported 

— VME64 modes supported: A32/A24/D32/D16/D08(EO)/MBLT64/BLT32 

— VMEbus interrupt handler, interrupter, and system controller 

— Includes byte-swapping hardware for little-endian and big-endian data  interfacing (patent no. 6,032,212) 

— Enhanced bus error handling 

— Passive heat sink design (no moving parts) 

• Standard features include 

— Celeron socket 370 processor 

— Up to 256 Mbyte SDRAM using one 144-pin SODIMM 

— 64-bit Intel® AGP SVGA controller with 2 Mbyte SGRAM 

— On-board Fast Ethernet controller supporting 10BaseT and 100BaseTX  interfaces 

— On-board Ultra DMA/33 hard drive and floppy drive controllers with  VMEbus P2 I/O 

— Two high-performance 16550-compatible serial ports 

— PS/2-style keyboard and mouse port on front panel 

— Real-time clock and miniature speaker included