GE DS3800DGTA Gas Turbine Daughter Card

GE DS3800DGTA Gas Turbine Daughter Card

Part Number DS3800DGTA Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockDS3800DGTA is a printed circuit board under Mark IV series GE. The GE Gas Turbine Board DS3800DGTA is made to fit into the drive quickly. Each corner of the board has a hole. Screws can be used to secure the board in the drive. This GE Gas Turbine Board also has a single 20-pin ribbon cable linked to it. 

There are 5 trimmer resistors and 6 wire connections on the PCB. There are also test points on this GE Gas Turbine Board. The GE Gas Turbine Board has its own slot in the board rack. The ribbon cable is positioned in such a way that it can easily fit into a connection on another board. To reach the connector, the ribbon cable must not be pulled or tugged. This is due to the fact that the control signals are carried by several tiny wires in the ribbon cable. The connection that connects the ribbon cable to the connector that connects the ribbon cable to the connector that connects the ribbon cable to the connector. If the ribbon cable is tugged, the connections may be damaged or lost. Make sure there is enough slack for the ribbon cable to attach comfortably to the other board.

SPECIFICATIONS:

Part Number: DS3800DGTA
Manufacturer: General Electric
Series: Mark IV
Product Type: Gas Turbine Daughter Card
Number of channels: 12
Input Pulse Rate: 10 Hz to 25 kHz
Input Voltage Range: 24 V dc
Operating temperature: -35 to +70°C
Size: 8.25 cm high x 4.18 cm
Repair: 3-7 Day
Availability: In Stock
Country of Origin: United States

Benefits

Single slot CPU 

Provides 1 Mbyte of battery-backed memory in the same slot (up to 512 Kbytes available for use by ladder diagram application program)
Supports floating point calculations 

Up to 12K discrete inputs and outputs (any mix - simplex mode only); 2048 voted discrete inputs, 2048 voted discrete outputs Up to 8K analog inputs (simplex mode only) and 8K analog outputs (simplex mode only); 1024 voted analog inputs 

0.4 microseconds per boolean function 

64 MHz, 80486DX2 microprocessor 

Supports IC660/IC661 I/O (and IC697 I/O in simplex mode only) 

Programmed by MS-DOS

, or Windows

 software products running on Windows

 95 or Windows NT

 over Ethernet TCP/IP or through the SNP port. 

Configurable data and program memory 

Battery-backed calendar clock 

Three position operation mode switch 

Password controlled access 

Remote programmer keyswitch memory protection 

Four status LEDs 

Software configuration (No DIP switches or jumpers) 

Reference information inside front door 

In-system upgradable firmware