GE-FANUC DS3800HAFA1E1F Mark IV PLC

DS3800HAFA1E1F

Processor Speed:100 MHz Memory Capacity:64 KB RAM / 128 KB ROM Communication Protocols:[ therCAT  rofinet  odbus Operating Temperature Range:-20"C to +70"C Power Supply Voltage:24 VDC Input/Output Channels:256 Digital I/O, 16 Analog I/O The GE Fanuc DS3800HAFA1E1F Mark IV PLC is a cutting-edge solution for industrial control systems, featuring a robust design and enhanced processing power that ensures seamless operation under demanding conditions. Equipped with a wide range of communication ports, this PLC supports both MPI and PROFIBUS DP protocols, enabling efficient data exchange with other devices and systems in the manufacturing environment. 

 With a capacity of 1 MB memory, it offers ample space for storing programs, data, and configurations, ensuring flexibility and scalability for future upgrades and expansions. Operating within a temperature range from -20"C to +60"C, this PLC is built to withstand extreme environments commonly found in industrial settings, ensuring reliability and longevity. Backed by GE  commitment to quality and support, the DS3800HAFA1E1F Mark IV PLC comes with comprehensive documentation and access to a vast network of technical experts, providing customers with peace of mind and unparalleled service throughout their project lifecycle. The GE Fanuc DS3800HAFA1E1F Mark IV PLC is a high-performance control module designed for industrial automation systems, offering advanced processing capabilities, reliable communication, and exceptional efficiency in various industrial applications.

Compatibility 

ƒ Compatible with any Series 90-30 CPU except IC693CPU321 and IC693CPU340. Configuration size is limited for CPU311/313/331, as described on the next page. 

ƒ Requires release 8.0 CPU firmware. The latest Release 10 is recommended, if available for the particular CPU. 

ƒ Requires CIMPLICITY Machine Edition Logic Developer PLC version 3.0 plus the appropriate service pack or special (or a version later than 3.0). 

ƒ Not compatible with the VersaPro™, Control, or Logicmaster™ programming software. 

ƒ The Series 90-30 Hand-Held Programmer (IC693PRG300) cannot be used to configure this module. New Features The Series 90-30 DeviceNet Master Module allows a Series 90-30 PLC to send and receive I/O data from a DeviceNet network. 

Module features include: 

ƒ Support for all standard data rates (125K, 250K, 500K) 

ƒ Support for 255 bytes input data transfer and 255 bytes output data transfer per slave 

ƒ Support for 3972 bytes of input data transfer and 3972 bytes of output data transfer per master 

ƒ Support for two I/O connections per Slave - Typically one connection is used for Polled and the other is used for Strobe, Cyclic, or COS 

ƒ Support for Poll, Strobe, Cyclic and COS I/O Connections, Fragmented I/O and Explicit Messaging 

ƒ Support for Unconnected Message Manager (UCMM) with 1 proxy connection per slave device 

ƒ Support for configuration of the global scan rate 

ƒ Support for configuration of update rates for Poll and COS/Cyclic on a connection basis 

ƒ Support for PLC-application initiated explicit messaging via a COMMREQ 

ƒ Master can be configured to operate as a slave simultaneously with master operation 

ƒ Configurable fault behavior on loss of communication 

ƒ Reports loss or reestablishment of communication with slaves in PLC fault table (configurable) 

ƒ Support for 64 network device status bits (note: the bit for the master itself is always zero) 

ƒ Firmware update via service port on module