GE DS3800HHRB Highway Receive Circuit Board

GE DS3800HHRB Highway Receive Circuit Board

Part Number DS3800HHRB Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockDS3800HHRB is a highway receive circuit board developed by GE. It is a part of Mark IV control system Features It has one long connector port that runs along one of the board's edges. On the right side, there is one red light-emitting diode (LED). 

On one edge, there are four test points labeled with the initials TP. Panel Power Distribution In addition to the 10A fuses in the Power Distribution Module, each supply has an internal 5A fuse on each side of the 125VDC bus. All connections from modules inside the panel to the Power Distribution Module are secured with 2-pin lockable connectors. The relays are powered by the redundant 28V, 6A power supplies [PS.RELl] and [PS.REL2]. They are designed in the same way as computer supplies. The two 15A fuses feeding Relay Module #I, [RELAYS], provide an option for fuse isolation between trip and non-trip solenoids. 

An MOV, a filtering capacitor, and a current limit resistor condition the feeds to the Contact Input Modules, [CIM]. There is an option for fuse isolation between Contact Input Modules. The Communicator monitors it to alert a blown fuse and specify which fuse has blown. The Communicator monitors all internal power supplies and generates an alarm if any of them are out of tolerance, or if there is an undervoltage or ground on the 125VDC battery bus. Algorithm "64D" performs this ground calculation.

Benefits

Single slot CPU 

Provides 1 Mbyte of battery-backed memory in the same slot (up to 512 Kbytes available for use by ladder diagram application program)
Supports floating point calculations 

Up to 12K discrete inputs and outputs (any mix - simplex mode only); 2048 voted discrete inputs, 2048 voted discrete outputs Up to 8K analog inputs (simplex mode only) and 8K analog outputs (simplex mode only); 1024 voted analog inputs 

0.4 microseconds per boolean function 

64 MHz, 80486DX2 microprocessor 

Supports IC660/IC661 I/O (and IC697 I/O in simplex mode only) 

Programmed by MS-DOS

, or Windows

 software products running on Windows

 95 or Windows NT

 over Ethernet TCP/IP or through the SNP port. 

Configurable data and program memory 

Battery-backed calendar clock 

Three position operation mode switch 

Password controlled access 

Remote programmer keyswitch memory protection 

Four status LEDs 

Software configuration (No DIP switches or jumpers) 

Reference information inside front door 

In-system upgradable firmware

APPLICATIONS

• Simulation 

• Instrumentation 

• Industrial control 

• Process control and monitoring 

• Factory automation 

• Intelligent networked PLC controllers 

• Automated test 

• Data acquisition