EPRO MMS6110 Dual Channel Shaft Vibration Monitor

EPRO MMS6110 Dual Channel Shaft Vibration Monitor

Product Features

Dual-channel design: two channels of shaft vibration data can be monitored at the same time, providing users with comprehensive information on the operating status of the equipment.

High-precision Measurement: Using eddy current sensor as the measuring element, it can accurately measure the radial vibration of the shaft to ensure the accuracy and reliability of the data.

Flexible Configuration: Supports a variety of working modes, users can flexibly configure the parameters according to the actual needs, to meet the application requirements of different scenarios.

Powerful data processing capability: Built-in microprocessor allows real-time processing, analysis and storage of measurement data, and supports advanced functions such as spectrum analysis.

Rich interface options: Provide RS232/485 interface, which is convenient for users to carry out on-site configuration and remote communication, and realise real-time data transmission and remote monitoring.

Reliable safety protection: Built-in self-test function can monitor the working status of sensors and modules in real time to ensure the stability and safety of the system. At the same time, the module also supports password protection operation level, effectively preventing illegal operation.

Technical Parameters

Input voltage range: -1Vdc to -22Vdc.

Sensor type: Eddy current sensor (e.g. PR642X series).

Measuring range: Depends on sensor type and configuration.

Accuracy: Better than ±1%FS (full scale).

Operating temperature: -25°C to +70°C.

Storage temperature: -40°C to +85°C.

Protection class: IP65.

Application Scenarios

EPRO MMS6110 dual-channel shaft vibration monitor is widely used in a variety of applications that require shaft vibration monitoring, including but not limited to the following areas:

Power industry: used to monitor the shaft vibration status of steam turbines, combustion turbines, hydraulic turbines and other large-scale rotating equipment to ensure the safe and stable operation of the equipment.

Petrochemical industry: used to monitor the shaft vibration of compressors, fans, centrifuges and other equipment, to prevent equipment failure and improve production efficiency.

Iron and steel metallurgy industry: it plays a role in monitoring the shaft vibration of rolling mills, continuous casting machines and other equipment to ensure the continuous and stable operation of the production line.

Transportation industry: in high-speed rail, underground and other rail transit vehicles in the shaft vibration monitoring, to ensure the safety and stability of vehicle operation.

Environmental protection industry: in the sewage treatment, waste gas treatment and other equipment in the shaft vibration monitoring, to ensure the normal operation of equipment and environmental indicators to meet the standards.

Operation and Maintenance

Operation guide: Users can set parameters and read measured values of MMS6110 monitoring module through the field portable machine or remote communication bus. During operation, please make sure to follow the operating procedures and precautions in the product manual.

Maintenance advice: Check the installation and connection of the sensor regularly to ensure that the clearance between the sensor and the shaft surface is within the specified range. Also, clean the sensor and module regularly to avoid the influence of dust and dirt on the measurement accuracy.

Instructions and warnings related to the operation of the product:

The following specifications must be strictly observed:

 The technical specifications and typical applications of the product system must be strictly observed.

 PERSONNEL TRAINING: Only trained personnel may install, operate, maintain or repair the product system. These personnel must be instructed on the

These personnel must be instructed and briefed on the conditions in the hazardous area.

 Unauthorised modifications: No modifications or structural changes may be made to the product system.

 Maintenance Responsibility: It must be ensured that the product system is only used under appropriate conditions and in a condition that is fully fit for purpose.

 Working environment: The user must fulfil the specified environmental conditions:

Safety regulations

The following safety regulations must be fully observed when (maintenance) work is carried out on the product system:

1 Disconnect completely.

2 Secure to prevent reconnection.

3 Confirm that the installation has been completed.

4 Perform grounding and short-circuiting.