GE IC697MDL653 Logic Input Module

GE IC697MDL653 Logic Input Module

Product Overview

The GE IC697MDL653 Logic Input Module is part of the Series 90-70 PLC family, which is known for its high performance, reliability and ease of use. The module is designed to connect external 24V DC signals to a PLC and convert them into signals that the PLC can understand and process.

Main Features

Number of input points:

Provides 32 input points to meet the needs of most industrial control applications.

Logic support:

Supports positive and negative logic and can be connected to various types of sensors and switches.

Electrical Characteristics:

Supply voltage: 24V DC.

Input Voltage: 24V DC.

Input Current: 2A max. per point.

Power consumption: 5W.

Environmental Adaptability:

Operating temperature range: -20°C to 60°C.

Storage temperature range: -40°C to 85°C.

Vibration: 5g to 2kHz.

Shock: 30g.

Protection rating: IP67 with high dust and water resistance.

Diagnostics and Indication:

Equipped with diagnostic indicator, it can indicate the status and fault information of the module, which is convenient for users to carry out troubleshooting and maintenance.

Installation & Dimension:

Adopts DIN rail mounting, easy to install and remove in the control cabinet.

Dimensions: 140mm x 60mm x 25mm (L x W x H), weight 200g, compact and space-saving.

FEATURES

32 Points - Four isolated groups of 8 points each 

Positive/Negative Logic Compatibility 

Proximity switch compatible 

Input filter selectable* - 1mS or 10mS 

One input configurable as interrupt*

Interrupt

When used with the IC697 CPU, input point A1 may be configured to cause a CPU interrupt. Configuration allows the CPU to be interrupted on either the rising or falling edge of the signal transition. Interrupt response is not affected by input filter time selection. Refer to the applicable Programmable Controller Reference Manual for detailed information.

Module Mechanical Keying

This module includes a mechanical key that prevents inadvertent substitution of one module type for another in a given slot. The key fits a uniquely shaped area on the board below the connector. Each module has a key packaged with it. When the module is first installed, the key latches onto the backplane center rail. When the module is extracted, the key remains in the center rail, configuring the slot to accept only identical module types. If it is necessary to change the module location in the rack after the key has been latched onto the center rail of the rack, the key can be removed by pushing it upward to unhook the latch while pulling it off the rail. It may then be reinserted onto the module and the module inserted into the rack in the desired location. Note that in an IC697 PLC rack only the power supply can be placed in the leftmost rack position, and slot 1 (adjacent to the power supply) must always contain a CPU (in rack 0 - the CPU rack), or a Bus Receiver Module (in an expansion rack).

Field Wiring

The module is wired as shown in Figure 3. Since each group of eight inputs is isolated from the others, a wire from the power source to the power input terminal (10, 20, 30, or 40) for each group is required (power input terminals for each group are not connected inside the module).

Removing an I/O Module

Grasp the board firmly at the top and bottom of the board cover with your thumbs on the front of the cover and your fingers on the plastic clips on the back of the cover. 

Squeeze the rack clips on the back of the cover with your fingers to disengage the clip from the rack rail and pull the board firmly to remove it from the backplane connector. 

Slide the board along the card guide and remove it from the rack.